Your cart is empty.
Your cart is empty.Top Shelf Hardware These oval rod end supports are amazing quality! If you're outfitting a new closet, you be glad to know that these are the perfect companions to our oval rods. But they're just as suitable if your aim is to replace the old end supports in your existing closet with something much nicer. Your closet never had it so good! "System Holes" Installation These end supports have two 5mm rear facing prongs that are 32mm apart. So if you have a closet system with rows of pre-drilled 5mm holes, you're in luck, because installation can literally be done in about 10 seconds, without any tools. Just pop them in at the desired height, put the oval rod in place and you're done! Of course, this assumes the rod is cut pretty precisely, as it serves to keep the end cups in place. If the rod is a little short, or you'd just like a little more security, add the provided 5/8" screws for good measure. "Old School" Installation If you don't have a closet with pre-drilled holes and just want to use our supports in a more conventional fashion, you can do that as well. Just use a 3/16" bit and drill a couple of corresponding holes into your closet wood cleating, insert the support, and secure it with the provided screw. Then install the rod, admire your good work and start hanging clothes! Drywall Installation Due to its nature, we don't recommend these end cups if you're looking to install directly over sheetrock. If that's your situation, please search in this listing for our full line of end supports that support that type of installation
