Your cart is empty.
Your cart is empty.Specifications: -PRESET 140-175 PSI -MINIMUM ON: 50 PSI -MAXIMUM OFF PRESSURE: 175 PSI -PRESSURE DIFFERENTIAL: 35-55 PSI -¼" COMPRESSION UNLOADER VALVE CONNECTION -¼" FEMALE NPT TANK CONNECTION WITH 3 EXTRA 1/4" FEMALE NTP PORTS. -MAX AMPS, 26 AMPS AT 120VOLT / 26 AMP AT 240 VOLT No Power Switch Dimensions: 4-3/4" Long (Farthest Point) 2-5/8" Wide (Farthest Point) 3-3/4" (Bottom of Manifold to Top of Lid)
GApilot
Reviewed in the United States on March 13, 2025
Great value, no issues with this switch. Still working after a year.
Christopher Caison
Reviewed in the United States on March 3, 2024
You get what you pay for. My neighbor and actually function in the capacity it was made for tossed it in trash Lesson learned
Tanya Rentmeester
Reviewed in the United States on March 27, 2024
Installed easily. Ajusted on off pressures slightly. It doesn't have the one/off switch which is not a big deal for my application.
Len M.
Reviewed in the United States on January 4, 2024
A high quality product that can standup to the stresses of removing all sizes of seriously seized components.
jerome p.
Reviewed in the United States on April 9, 2024
no instructions on how to reset on/off as i dont want pressure to get to 175 lbs pressure no paper work came with it need instructions
Don H.
Reviewed in the United States on September 13, 2023
Had to use some of the old parts off my replacement switch to get this one going.I would had been nice to have a little instruction sheet to fine tune the 2 air pressure adjustments.Inside the cover told you what they did, but which one to adj. first.Need to work on more of them.
Michael J
Reviewed in the United States on August 25, 2022
Functionally, the unit works as advertised, but inside is a plastic Tee bar that forces the contactors apart at the end of the cycle, but due to heat created from delatching the contactor reed, it melts that plastic lifting bar which results in 1 or both contactors being left in the closed loop state. If they fix this 1 flaw, I expect that unit would last longer, but it is what it is...
RedRanger
Reviewed in the United States on November 8, 2021
This Air Switch fit my Puma, 6 HP Compressor but one air line needed modification to hook up.It actuates but I have another problem so I can't tell you yet IF it is the Switch or the Motor.I will post again once I determine my problem.Update: 05/23/2022 - The Switch installed and I was able to reroute the air line to compensate for the different location; not a big problem.Works and works well, cycles the compressor at factory set pressure points and I haven't done it but it is adjustable, within parameters from the factory.I have added an additional Electrical On/Off Switch as the main power shut off, this Pressure Switch only needs to cycle the compressor.Note: The On/Off Switch on the Pressure works ok.Overall this Pressure Switch works well on my Puma Compressor with only minor air line adjustments.Since I could not get a Pressure Switch from nor info about the Pressure Switch used from Puma, I tried this one and it worked... enough said !Saved money !
Recommended Products
