Your cart is empty.
Your cart is empty.Sigma's Conduit hangers are used to secure and suspend EMT, Rigid, IMC and PVC conduits from overhead supports. The Conduit hangers come pre-assembled with carriage bolt and nut for secure installation.
J
Reviewed in the United States on January 28, 2025
Used to run conduit in my quonsit. Worked great for my application.
GearJunky
Reviewed in the United States on December 22, 2024
The hanger did work for me, but I had to run the nut all the way down to the point that there was very little of the bolt left. It would have been better (in my case using 1/2" conduit) to use a much shorter bolt with a full thread. I do understand a longer bolt is supplied in case you are clamping something with a bushing on it, but as intended, hanger to #0 conduit, the hardware is a fail.
Michael James Sr
Reviewed in the United States on September 23, 2023
They worked just fine.
Gordon Steeves
Reviewed in Canada on August 1, 2023
It’s a clamp
Jim B.
Reviewed in the United States on November 4, 2023
It's a simple product with a straightforward job, but as simple as it may seem it must be designed properly with the correct materials to do that job correctly. This product does that!
mom lady
Reviewed in Canada on July 19, 2022
These aren't nasty "over there" products - they are all symmetrical in size (rare these days) and fit well. Also hard to find these days for some reason. Very hand to have on hand for other uses too.
Steve
Reviewed in the United States on February 14, 2022
ordered wrong size....not suitable for 1 inch diameter conduit.
Larry Tosi
Reviewed in the United States on January 14, 2022
Good
SKIDAWG
Reviewed in the United States on July 1, 2021
Worked fine.
Sam Ashley
Reviewed in the United States on October 11, 2021
It was what I needed for the job. Perfect size for pipe I used.
Recommended Products
