Your cart is empty.
Your cart is empty. New O-ring Kits 900420 For Paslode Cordless Framing Nailer
Part #:900420
Ryman
Reviewed in the United States on March 29, 2025
Do yourself a favor and buy the good ones. You’ll end up doing it anyway. 😩😎
A D Hogg, Jr.
Reviewed in the United States on March 1, 2024
As advertised
GARY SICH
Reviewed in the United States on June 14, 2022
PRODUCT IS JUST A SHADE UNDER OEM AND WILL NOT GENERATE ENOUGH BACK PRESSURE FOR THE GUN TO WORK CORRECTLY
Neal Veon
Reviewed in the United States on October 18, 2022
O-rings seemed to be good quality but too small for my Paslode Impulse framing nailer. They did not make a good seal. May fit newer models. My gun was purchased in 2002.
Stretch Cassidy
Reviewed in the United States on March 2, 2020
I received 2 orings for a 900420 and neither is correct, causing hammer to stay extended and poor power. Do not buy this product.
Tracy
Reviewed in the United States on December 31, 2020
Don't waste your money, these do not work appropriately.
Customer
Reviewed in the United States on September 10, 2019
I purchased these vs waiting on local dealer to order parts as Amazon has best shipping times. Big Mistake! I had to order from OEM anyway as these do NOT fit a 900420 older style framing nailer as advertised. See pictures shown on fan seal area as they are close but under size, Paslode OEM parts brown and these are black. These parts are small and do not protrude out of the groove and provide no seal. Highly disappointed here as both O-rings for the fan and mid section were both under sized and not usable and caused an extra delay to get moving again.
TIM PRANGER
Reviewed in the United States on November 21, 2019
Ordered these online to repair my guns. The o rings are slightly smaller the "Paslode" labeledrings and they are not heat resistant like the manufacture parts. Did not last for cylinder of gas.Went to Paslode service center and purchased the Paslode o rings and gun works great. Don't getfooled.
Recommended Products
$19.99
$ 8 .99 $8.99