Your cart is empty.
Your cart is empty.
Most radio wire pins is vary by model, you may had to move a pin to match with factory plug.
Geting power from ignition with red cable provided to ensure there is 12 volts supply.
Not compatible with amp systems like Bose, Infinity, On-Star etc
Cayl S.
Reviewed in the United States on July 17, 2024
The connector did fit and I eventually got the job done with it. However several of the wires were not marked (a few were marked) and the unmarked wires were all the same color so you couldn't tell what was what. I ended up guessing and through trial and error I completed it without needing to cut the original harness in the car. Horrible product. 2004 Toyota Avalon XLS JBL system.
Maxvicious
Reviewed in the United States on May 25, 2024
this works great if you want to change the receiver but keep the JBL amp from factory
Sunny Side Up
Reviewed in the United States on February 29, 2024
I am in the process of replacing both of my 1st gen tundra's and sequoia's radios. The plug is exactly what I needed, good quality, and OEM fit. Easy to connect and read instructions.
AmZFanSince 1995
Reviewed in the United States on February 11, 2024
No issues and fit tightly into my 2004 Sequoia amp connector
Alex Melnik
Reviewed in the United States on November 10, 2024
The wires are of very low quality, they are not pure copper, so they cannot be soldered.
Edward J Noworyta
Reviewed in the United States on October 25, 2024
Nothing came with this harness to tell me what wire color is what. Really that wouldn't matter, because which of the 4 green wires go to what from the deck? Why is there 4 grounds? What blue wire does what?
gone fishing
Reviewed in the United States on December 19, 2023
This is a specific use item
Recommended Products
