Your cart is empty.
Your cart is empty. Package List:
4x Wheel Hubs Hex Sets
4x Axle Pins
Product Weight: Approx. 38g
Feature:
1. High quality offset wheel spacers for 1:10th RC crawler trucks.
Note:
1.Actual product may vary slightly from photos shown. Please allow us to have some slight measurement errors.
2.Please feel free to contact with us if there is any quality issue, we will try our best to make you satisfied.
Ryley W
Reviewed in the United States on March 14, 2025
Does not fit rustler 4x4 vxl. The internal dimension of the spacer is too small to fit all the way to the hub and would require modification. With trencher wheels and tires the hex is not long enough so there is no way to tighten the nut all the way.
jared
Reviewed in the United States on January 6, 2025
Other than not being an exact fit with a little sand paper and time they work great. For the price though hard to beat.
J. Mike Martinez
Reviewed in the United States on August 9, 2024
Just like the description says.
Phillip
Reviewed in the United States on August 6, 2024
Just what I needed
@lunchmoney99
Reviewed in the United States on January 28, 2023
Didnt quite realize i would need to drill the hole in my wheels bigger to fit the "lugnuts" but once i did everything came together perfectly. Slight slop in the setup but it gave my drift car a wider stance. If you dont want to drill your wheels get something different.
Jaime cardenas
Reviewed in the United States on April 15, 2022
this is a solid product im currently running them on my traxxas bandit/rustler yes best of both rc’s mixed into one lol so far no issues with breaking apart like most folks state here im running a castle creations sidewinder 3 on a 2s lipo batt on stock driveshafts and no issues i have beaten them flipped my rig smoked the wheels off no issues i suggest do you're research instead of complaining
Aaron Carey
Reviewed in the United States on April 25, 2021
Fit and finish in fine. You will probably have to drill the wheel out a little since it's going down between the wheel and axle. (common sense). Also they will need some thread lockers since they're obviously not nylon locking nuts. (common sense)
april towner
Reviewed in the United States on December 10, 2020
Ordered two sets. Put them on a scx 10 ii and redcat axles. Work great. I do recommend using loctite on the treads to keep from loosening. Tight fit on red cat wheels and not as tight on axail rims. You will need to drill center hole to 13/64 to fit new nut.
Recommended Products
