Shopping Cart

Your cart is empty.

Your cart is empty.

RC Nitro Car Pull Starter R020 Recoil Starts w/ 12mm R025 One Way Bearings for 1/10 VX 16 18 SH 21 Engines

Free shipping on orders over $29.99

$14.99

$ 7 .99 $7.99

In Stock

About this item

  • Fit for 1/10 RC nitro car trucks
  • Across center fixing hole size (center to center):27mm
  • 12mm across flat one way bearing, 6mm shaft diameter
  • Please gently pull the start string and add some extra wax for lasting performance;Please notice that the pull start is not suit for all 16-21 nitro engines, pay attention to the actual size of your cars
  • Buy with confidence: Free replacement without return for cord broken within 30 days. If you are facing any problem, please feel free to contact us


Note:
1.Actual product may vary slightly from photos shown. Please allow us to have some slight measurement errors.
2.Please feel free to contact with us if there is any quality issue, we will try our best to make you satisfied.


Andrew Griego
Reviewed in the United States on May 30, 2024
Easy installRope will tear easily
Solitary Angel
Reviewed in the United States on May 20, 2024
Got my nitro truck started for a few seconds but died on second attempt the string snapped at the knot. Pulled the starter off and fixed it after a few pulls the string snapped again! The one way bearing works great and the actuall pull starter works well too. Save you sometime and headaches and replace the string with #18 nylon braided mason twine 250ft for around $6 at home depot. It has a tensile strength of 155lbs and its mildew and abrasion resistant. Its also very close to the same diameter of the original around 1.5mm.
RJ S.
Reviewed in the United States on May 16, 2024
Broke mid pull before I could start the truck(5 pulls). Just buy TRX5170, never seen one break.
Lee Sprague
Reviewed in the United States on May 29, 2021
Showing the dimensions really helped getting the correct one
Paul P.
Reviewed in the United States on February 18, 2021
bolts up to my traxxas tmaxx...so far its doing well only used it a few times, the string does seem pretty darn thin but we will see, i held the rope and pulled on it pretty hard and it didn't break, if you are breaking this string first try then you must be really pulling on it extremely hard. I also added another knot to the top.Update string broke, got another one and the second one is junk as well.
Mike Reynolds
Reviewed in the United States on February 13, 2021
It good
Cody Juenke
Reviewed in the United States on September 5, 2020
Fast shipping fits great
Benjamin Nickles
Reviewed in the United States on July 24, 2020
Rope broke on third pull. Fixxed with a new cord works like a charm!