Your cart is empty.
Your cart is empty.RC Drive Shaft
c
Reviewed in the United States on March 26, 2024
Snaped one first 1st hour of running.
Thomas Shattuck
Reviewed in the United States on October 27, 2024
Snapped at knuckles, 10 min snap 20 min snap.
John
Reviewed in the United States on February 1, 2023
Only used the car two times and there falling apart
Heart Like a Dog
Reviewed in the United States on September 27, 2022
They are installed and working BUT!!!. the end of the shaft that comes through the bearings is 1.2mm too short and the threaded part is .05 mm too short. Together that is roughly .045 in length or 1.7 mm doesnt seem like much but if I tighten the wheel nut to engage the nyloc insert the wheel becomes too tight because the nut is not bottoming out on the step on the shaft as it should be and will not turn. Must back them off slighly then use blue loctite to secure the nut. We shall see if they stay on. Maybe if I swap to aluminum steering knuckle they would work better. But thats MORE money and the budget has gotten much more DEMOCRATIC these days, if ya know what I mean
Andy K.
Reviewed in the United States on October 22, 2022
Stock dog bones seem to have a little bit more play with upgraded parts but the cv axles fixed the problem nicely thank you
Customer
Reviewed in the United States on October 1, 2022
I have a tornado exp pro and these are just a tad bit to long. Seems like they are pretty good quality the only thing is you can’t bottom out the suspension out with these installed. If you don’t really bash the car these should be fine. It’s a cheap redcat so I’m just going to run them until the car breaks again.
Recommended Products
