Your cart is empty.
Your cart is empty.Product Description
- Water can get into the engine bay easily.
- After installation , the engine grille will be blocked by this TPE cover for washing.
- If the rear engine cover is not installed during car washing, foam and water may enter the engine compartment, leading to rusting, deterioration, and accumulation of dirt on the components.
- Easy Installation.
- It can be reused.
- After use, remove it and place it in a cool area to air dry naturally.
- To extend the product's lifespan, please avoid prolonged exposure to direct sunlight.
- Customed design ,perfectly compatible with your c8 corvette.
Jacqueline Damron
Reviewed in the United States on March 9, 2025
Easy to use, keeps engine area dry when washing corvette. Fits perfectly. Looks nice. Definitely recommend
Customer
Reviewed in the United States on March 6, 2025
These are just what I wanted and needed. They completely snap into both sides of the vents and there is a piece that slides under the open window. Unlike other products that need you to do all kinds of taping to keep the water out, these will do a very complete job. You need to slide the side pieces up into position to get a good seal. The window seal needs to start at one corner and work your way around until it is all tucked in. Great design.I saw a review on another site about a similar product complaining that they didn't stay in driving through a car wash. What? These are for hand washing your car. I would never go through a car wash in the first place and I certainly wouldn't expect them to stay in if I did.
Chase
Reviewed in the United States on March 13, 2025
These fit in the air vents on a C8 Corvette. The rear engine has vents to exhaust the heat. When you wash the car water gets inside it tends to get a lot in the engine compartment. It doesn’t create damage, but it looks unsightly. These stop water from going in the ventilation ports in back of a C8 Corvette. They’re exact fit, so they are a little snug going in. What I do is I leave them upside down out in the sun for a few minutes before trying to put them on and they fit right in where they’re supposed to. These are not an inexpensive, but they seem to be very well made.
Amanda
Reviewed in the United States on March 10, 2025
These are really good for keeping water out of your engine through the vents. They are a bit rough to get fitted in correctly especially the window opening. Once you get them fitted they work well and can stand up to a decently strong power washer.
Recommended Products