Your cart is empty.
Your cart is empty.Product Description
Redcat Racing Part # 02051T upgraded front/rear differential housing. Compatible with the following Redcat Racing vehicles: lightning EP drift, lightning EPX pro, lightning STK, lightning STR, SANDSTORM, SHOCKWAVE, Tornado EPX/EPX pro, VOLCANO EPX/EPX pro. Redcat Racing is located in the United States and has a full staff of support personnel to help you with your Redcat Racing product. Consult your vehicle manual for correct fitment and assembly. Since 2005 Redcat has been your source for fast - affordable - fun!
From the Manufacturer
Lightning EP Drift, Lightning EPX PRO, Lightning STK, Lightning STR, Sandstorm, Sandstorm TK, Shockwave, Tornado BB, Tornado Epx/epx PRO, Tornado S30, Tsunami (nitro), Tsunami EPX, Volcano Epx/epx PRO, Volcano S30, Volcano STX, Vortex Epx/epx PRO, Vortex SS.
David Henson-green
Reviewed in the United States on December 16, 2024
Fits together well, you see a small gap once you install the two half’s and put the top screw in but once it’s installed on the chassis and the other screwed go into the diff it pulls it all together as it should and it fits perfectly.
Kyle Robertson
Reviewed in the United States on November 4, 2024
Replacement for front diff just swap bearings and gears over and ready to go
Joe D
Reviewed in the United States on October 16, 2024
Great
Charleesa Coley
Reviewed in the United States on January 5, 2020
This is an exact replacement for redcat/hps models that use it. My pinion/diff from a volcano dropped right in and needed no shimming. The screws that hold the shock tower screw the top of the case together, don't over-tighten them or you'll break it.
Shaun K
Reviewed in the United States on July 10, 2018
It’s very hard to find the right tightness but once you get it right it very smooth I’m going to upgrade to aluminum later
sootlife
Reviewed in the United States on May 21, 2017
Sold as an upgraded part, same as stock part
Robert P.
Reviewed in the United States on December 28, 2017
This gearbox doesn’t fit together very well. It took quite a bit of work to get it together, and then there is a pretty large gap along the top. Hopefully there’s no binding inside once I get it running. I’ll update.
Giselle k.
Reviewed in the United States on April 27, 2016
Only problem I had was the bearing Seat was too big so the bearing kept falling out.
Recommended Products
