Your cart is empty.
Your cart is empty.Product Description
Product Diemension
Series: M7, LE, VALUE, EL
Manifold Length: 15"
Manifold Diameter: 2"
Kilowatt Rating: 4.0KW / 1.0KW
Voltage Rating: 240V / 120V
Number of Mounting Studs: 2
Tail Pieces Included: Yes (removable)
Tail Piece Size: 2" x 2" (removable)
Perfect Fitment：Suitable for most of Balboa VS, EL, TS, GS, and BP Series control systems
Replace Part Number:
52756,55624,55625,55689,55813,56487,58000,58002,58010,58016,58032,58083,58086,58089,58091,58103,58104,58105,58117,58121,58123,
58130,58148,58209,55464,55473,103017,106957,58064,26-0807-5S-K, 26-0807-7S-K,26-807-5S-KS, 48-SP40-SB,48-SP55-FB,740-0617,
740-0655,9711-207, C2400-0807,C2400-0807-TPS,C2550-0807,C2550-0807-TPS,X300713,X300930, X300935,X300943,X333131,X801761
Installation Notes
Step 1
- Disconnect the power supply of the equipment.
- Use an open end wrench to slowly crack the heater split nuts until the water in the pipe flows out
Step 2
- Locate the 2 sensors holder on the circuit board.
- Remove the 2 heater sensors by depressing the clip and gently pulling on the wire to remove each sensor cable
Step 3
- Use a 3/8” wrench to remove the 2 nuts holding the heater in place
Step 4
- Use a 3/8” wrench to remove the nuts on the copper straps.
- Then lift the copper straps
Step 5
- Use an open end wrench to loosen the heater split nuts and remove the old heater assembly and gaskets
Step 6
- Replace the new gaskets and install the new heater assembly, tighten the split nuts with an open end wrench.
Step 7
- Screw on the 2 nuts that holding the heater, insert the 2 heater sensors into the sensor bracket on the circuit board, make sure the copper strip is connected to the heater and tighten the nuts.
Step 8
- Put the cover on and screw on the 2 screws on the top of the enclosure.
- Turn on the water valve and pump, restore the power of the equipment, and test
Constance Roller
Reviewed in the United States on March 25, 2025
Works great and easy to install.
Jason
Reviewed in the United States on February 14, 2025
Had to return item twice. Both times ordered, the heating element post were bent. It felt like I received the same item back on second order because it looked the same. I gave them the benefit of the doubt and thought maybe it’s just how it’s manufactured. So I tried to install. Instantly, water started leaking through the bent post. Had to return the item again and ordered with a different company.
Recommended Products