Your cart is empty.
Your cart is empty.Front track bar relocation bracket from Rugged Ridge.
Customer
Reviewed in the United States on March 2, 2022
Like others said there is only one bolt, but even then the design does not allow for too much movement. It made the angle of the track bar match the drag link. That’s with stock springs, SOA, and a 4” drop pitman arm. I did put a one inch bead on it with 110v Cheap-o welder to eliminate the possibility of play. Literally took 20min to install to include getting the welder out. This seemed much less time consuming then drilling holes required for other types of relocation brackets.Side note regarding track bars: I drove for 4 years (daily driver) without a track bar cuz the internet said I didn’t need one. I had a new 4” SUA lift sitting in 35’s at the time. For a good while I thought it was fun how it tended to wander about the highway and pull under hard breaking but then it got old. New brake calipers, ball joints, steering box(manual to power steering) tie rod ends, etc, all made small improvements but it still wandered/pulled. Recently switched to SOA and that seemed to make the wandering a little worse so I decided to add a track bar back in. What an amazing improvement on the steering. Tightened it right up. No more wandering. I will replace the stock track bar with a JKS slide type bar soon to get some flex back.
Roger F
Reviewed in the United States on January 30, 2019
Overall it will work, however with only a single hole for mounting to axle it will always move.It does its job but could be easily improvedFull time 4x4 mechanic, 30 years of experience
HD-Rider1958
Reviewed in the United States on January 6, 2017
Ended up returning this, my alignment shop mechanic also said that this design has a tendency to loosen up. For a few dollars more I ended up going with the Rough Country version, much sturdier and attaches at Two places instead of relying on one bolt. Apparently Rugged Ridge never acknowledged the return and 4 months later I am being billed for a part that's a piece of Cra$p. WILL NEVER ORDER ANYTHING FROM THIS COMPANY AGAIN! BUYER BEWARE!!!!
Billy
Reviewed in the United States on January 9, 2016
great
Lucas C.
Reviewed in the United States on February 6, 2015
I lifted my 95 wrangler about 4 inches and this was perfect for the track bar.
M. Miller
Reviewed in the United States on November 28, 2015
Does not work . It allows the track bar to push this back and forth .. Terrible design . Instead of welding on , I'm buying a different brand that has a lip which prevents movement .. Do not buy .
Recommended Products
$36.61
$ 17 .99 $17.99