Your cart is empty.
Your cart is empty.Leona
Reviewed in Canada on February 17, 2024
Fit my sons foreman perfectly.Great value for the money.Highly recommend!
Paul S.
Reviewed in the United States on December 8, 2024
Retention bands for the boots were loose apon arrival I should have just sent it back then. I replaced the bands installed the axle and it was loose in transmission test rode the ATV and get a chatter in the rear. Removed the axle and measured the splines comparing to original OEM Polaris axle splines these are definitely under size. Measured with micrometer and pins or what us machinist call thread wires. Also tried to remove the outer CV joint and dose not come apart like a Polaris CV joint the inner CV joint comes apart to replace CV boots.
Greg L.
Reviewed in the United States on November 2, 2024
Good replacement axle
Customer
Reviewed in the United States on November 12, 2024
This was installed on a 2005 Polaris Sportsman 400, after a breif ride, 15 minutes, the boot had came off, grease everywhere and it was poping and cracking worse than the one I had replaced it with. Keep scrolling for something better, whatever you get won't be as bad as this
comanche
Reviewed in the United States on October 28, 2024
Worked great
LARRY SMITH
Reviewed in Canada on January 26, 2024
fast shipping good quality product
martin strenk
Reviewed in the United States on May 26, 2023
fits a Polaris sportsman 700 2003 as advertised
Brad
Reviewed in the United States on January 8, 2023
Went in smoothly on 2003 Polaris Sportsman 400. Watched couple of youtube videos for the install and worked great. Get a couple of small breaker bars to pry on the old one to pop it out. That was the toughest part, then getting this new one in was very easy.
Customer
Reviewed in Canada on September 30, 2022
junk
Bob The Builder
Reviewed in the United States on March 27, 2022
Hard to install be works well.
Customer
Reviewed in the United States on November 5, 2022
I've had these axles just a few months, the boots of one of the axles already has a hole on it. It is not from a puncture, it is from poor quality in the manufacturing of the booth.
Recommended Products