Your cart is empty.
Your cart is empty.Smittybilt XRC Armor Corner Guards are manufactured from 3/16 inch cold roll steel, and are hand crafted to insure a perfect fit every time. Each Corner Guard is available with or without a 3 inch flare, and includes stainless steel hardware. They are finished in a black powder coat and can be used with the XRC Armor Rocker Guards, as well as our XRC Armor Tube Fenders.
Ella
Reviewed in the United States on June 12, 2024
Items arrived damaged and missing bolts kits. Contacted Smittybilt and they’re on back order. So not only am I out money but they want ME to PAY to ship back a damaged missing parts product. Let’s not talk about the shop fees already accumulated or my time running back and forth. High no NOT recommend dealing with this seller. Now I have to drive an hour and a half to go get my Jeep that has no fenders still and somehow wait to hear back about shipping being covered.
Blake on the Lake
Reviewed in the United States on April 17, 2024
Make sure you measure everything. And when the directions say 3/8x1" They might mean 10x1.50m
Jeff
Reviewed in the United States on January 9, 2018
Hard to install. Removes License plate. Very durable. Couple videos out there. Buy a real nutcert tool.
Sergio Gonzalez
Reviewed in the United States on January 26, 2018
Pain to line up and make holes for but looks amazing.
Daniel Serrano
Reviewed in the United States on January 22, 2018
GREAT!!
Luis Diaz
Reviewed in the United States on May 5, 2016
It looks sick, no doubt, but you chaps already knew that.Let me tell you why this sucks:The fronts are easy to install, this is totally about the rear panels.Installation nightmare. 2 of 3 bolt locations on the top of each rear panel are impossible to get to, cant mark them, cant even squeeze in the damn bolts.Nutserts. 3/8 nutsert is an odd size. I went to no less than 6 shops around my area including harbor freight and grainger, no one had the tool i needed, keep in mind the hand tool you are provided with, sucks.Its a 2 man job to do it right.The fit isnt a perfect seal.As i said, looks good but you are better off paying to have it installed. I now realize why there were no how to youtube videos.... No one was that stupid.
Customer
Reviewed in the United States on April 27, 2016
excellent fit, instructions were a little unclear, but I was able to figure it out, and move on. they look great! there needs to be a better solution offered in marking where the nut zerts. are mounted.
D. M
Reviewed in the United States on August 7, 2015
nice and beefy
JK_Hammer_47
Reviewed in Canada on July 11, 2014
Nice looking, very durable. Installation was tricky to say the least. Be prepared to measure and align over and over before you start drilling the mounting nut-cert holes. there where differences/variations between to the two rear corner guards, one side fits better then the other when compared to the original body lines. Also, I already had the XRC rear bumper installed prior, and found that these guards DO NOT marry well (even though they are XRC) and require modification/cutting to clear the XRC tire mounting bracket. Oh Ya, another pain was that some of the nut-cert locations are almost impossible to mark, and get a wrench on to tighten. Be very patient when installing these, and do not force the corners to match any original body lines, because they never will. If you still want to use your original inner fender liners, like I did. You'll need to cut and trim them so that they fit flush with outer body to wheel well. This part was NOT IN the installation guide.
Recommended Products
$119.99
$ 54 .99 $54.99