Your cart is empty.
Your cart is empty.These C6/C7 Corvette Lowering Bolts are the perfect performance and appearance enhancing suspension upgrade for your Corvette. Adding to its aggressive looks the Lowering Bolt kit will lower your Corvette's center of gravity reducing squat during acceleration, body roll in corners and nose-dive under braking. Easily lower your C6/C7 Corvette up to 2 1/2" with these specially designed lowering bolts. The Corvette Lowering Bolts will increase handling as well as adding an aggressive edgy look. Sold as a set of (4).
Jose flores
Reviewed in the United States on January 7, 2025
They made the job easier on my 2007 chevrolet corvette
steve
Reviewed in Canada on August 5, 2023
Well made puts the car at a nice ride hight
Kevin Gardner
Reviewed in the United States on May 19, 2023
Changed the car
Gabriel Elderzi
Reviewed in the United States on April 11, 2023
These lowering bolts paired with bilstein b8 have improved the look and handling tremendously. Great improvement over stock! Photos show the lowering bolts at their lowest setting.
Carlos duque
Reviewed in the United States on January 8, 2020
These things are amazing for the price I've bought more expensive versions which were terrible and made noise these are as close as you're going to get to OEM while lowering your car the right way.
Charlie
Reviewed in the United States on November 7, 2019
Took a hole saw to a hockey puck and countersunk this into it to get a replica of the stock item. Saved a couple of hundred dollars. I would have had to purchase an entire spring assembly to get the part. Just another stab in the back courtesy of GM / Corvette.
Matt
Reviewed in the United States on April 26, 2019
It did the job it was said to do. Very easy, straight forward install.
OmarBuilds
Reviewed in the United States on April 27, 2017
Installed on my C6. Easy PZ. 1) remove wheels 2) unbolt and remove shocks 3) unbolt upper control arm ball joint 4) let a-arm assembly hang, careful of the abs sensor wiring (unplug) and brake line 4) unscrew old spring bolt and pull from bottom of spring. You might need to push down on the a-arm assembly a little. Install is reverse. Then get an alignment! Love how easy it is on corvettes to lower.My originals were sheared in half some how, but I never noticed it and the ride height never changed.
TCE
Reviewed in the United States on February 23, 2016
I had to get these to replace a broken stock one. The broken side went on just fine, but the other side would not screw in. These are .3mm larger than the stock ones, or at least the stock one in my cars right rear. I had to buy a 14mm X 2.00 Tap to run through the nut in the spring. Either way, giving this 5 stars because it was probably GM's quality more than the actual product (I tested both on a 14mm x 2.00 nut and both went on fine).
Recommended Products
