Your cart is empty.
Your cart is empty.
SST-1001 - Shift Lever Seal Remover / Installer
Provides the easy removal and installation of the manual shaft (shift lever) seal. Draining of the transmission fluid is not required. The whole process takes just a few minutes.
Similar to:
Atec Trans-Tool T-1001, Kent-Moore J-26282, J-26401, KD Tools 2393, Snap-On YA9348 and Schley SL96480.
For use on these Transmissions:
180,180C (3L30) (4L30-E) Short Shaft Only 200, 200C, 200-4R 250, 250-C, 350, 350C 325,325-4L 375,400 (3L80), 425, 475(3L80-HD) 700-R4 (4L60) (4L60-E Pre 1995 Short Shaft Only) POWERGLIDE
Instructions:
To remove the seal:
1. disconnect selector shaft linkage.
2. place remover over the shaft with the remover screw backed off.
3. Apply downward pressure by force or with light tapping with a hammer while screwing clockwise into the seal. once the remover threads are engage into the seal, remove the seal by turning the remover screw until seal is extracted.
To replace the seal:
1. place the new seal on the selector shaft.
2. Place installer over end of selector shaft.
3. Apply downward pressure by tapping with a hammer.
4. Remove the installer.
5. Connect the selector shaft linkage.
James Riggs
Reviewed in the United States on July 4, 2024
Told exactly what it's speed to do I love it removes the deal with ease and installs easily to
Old Bolt Buster
Reviewed in the United States on February 28, 2024
This tool worked great! Removed the seal and installed the new seal! I'm a mechanic 38 years . This is a good tool !
Tyler Sapp
Reviewed in the United States on November 16, 2024
Bought this for a th400 seal, but it didn’t work. Wasn’t the right diameter
TriciaS
Reviewed in the United States on August 13, 2023
So far it seems to be working just fine. Thank you.
Customer
Reviewed in the United States on August 10, 2022
It scarred up my shift shaft so now I have to replace it, and it didn't even try and pull the seal.
Bam444
Reviewed in the United States on November 20, 2021
bought this to replace the last seal that was leaking on my 700r4 and it warped the "threaded end" and smashed my old seal farther in broke my gear selector shaft. this 30$ tool just cost me more money.this tool needs to be hardened if its gonna be hit with a hammer or have metal metal contact
Amanda Olinger
Reviewed in the United States on October 31, 2019
Didnt screw right into seal had to assist with hammer, but saved alot of time
Turkeyfeather
Reviewed in the United States on November 5, 2018
Tool does not engage seal. Lacks hex head on barrel so it is virtually impossible to tighten into seal and get engagement for the extraction. Buy the NAPA version instead, it has the hex head on the barrel and works well.
Recommended Products
