Your cart is empty.
Your cart is empty.Ryan Correll
Reviewed in the United States on March 9, 2025
Could have gone without . it fit well but isn't the best feeling in your hand. I could have gone without but for the price it could be worse.
Donavon Summers
Reviewed in the United States on August 22, 2024
Was a perfect replacement grip to the staple gun that I put it on. I know I know this is for a handgun but it was just the right size for the staple gun I use at work and was able to easily stretch and fit it on.
vlldavid
Reviewed in the United States on December 13, 2024
It tore when I tried to put it on. So in the trash it goes.
Lynn
Reviewed in the United States on September 10, 2023
Solid grips that resist dampness & moisture. Put these on two of my AR pistols , and they provide a solid , good feel . A bit labor intensive ( be patient..lol ) to install , but worth it. Most likely the fit is not for everyone, but a personal preference. I have average-sized hands & they provide the grip i prefer.
Chazmanian
Reviewed in the United States on June 3, 2023
Orphaned by the marketplace over time, for several of my older firearms there's not much to offer from the mfg or third parties for custom grips. My solution in some cases is this simple Stekos rubber "tube" that stretches into place easily, then trims to fit if needed. It's inexpensive, durable and conforms better than stick-ons for my use. In my latest application on the butt of a TASER Pulse, I pulled up the grip at an angle to make it higher in the rear. For my large hand, this improves the safety and accuracy of a shorter butt that I can only grip with two fingers below the trigger guard.
Crypto
Reviewed in the United States on August 21, 2022
I didn’t expect much, but was still let down. It doesn’t fit, rolling the rubber creates a slick Surface. chances are you will need to cut this overpriced junk to fit on most pistols. Might as well use grip Tape and save some bucks.
Raw
Reviewed in the United States on August 21, 2021
Had to cut to fit.A small issue is the grip now holds onto the holster when drawing and pulls the holster out with the weapon.The holster was not on a belt just slide inside a pocket.The belted holster does not have this problem.I may cut it down further below the hammer trigger areas so it is not in contact with the holster.The item works and is not moving once you position it on your grip!Beware that like with issues above, practice with the new grip as your grab and draw change due to the material grip and new thickness.
Robert F.
Reviewed in the United States on October 26, 2021
Bought this for my Taurus G3c. This is a great grip, but for my G3c it was too large. The result was that it was a little baggy at the back of the bottom of the gun's grip, and I just couldn't get it to work even careful cutting and shaping. I was disappointed, because I really liked the feel of the grip, for it feels great in your hand, being soft and tacky and yet very stable at the same time. So in the end, I would definitely recommend this Stekos gun grip highly, but not for the Taurus G3c. If it were offered in multiple sizes, that would totally solve the problem. This one was just not small enough for my particular gun's grip and that is a shame, because if it had fit, it would have been perfect!
Recommended Products
