Your cart is empty.
Your cart is empty. This bipolar Nema 23 stepper motor with 1.8 deg. step angle (200 steps/revolution).
Each phase draws 2.8A, allowing for a holding torque of 1.26Nm(178.4oz.in).
Electrical Specification:
* Manufacturer Part Number: 23HS22-2804S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 1.26Nm(178.4oz.in)
* Rated Current/phase: 2.8A
* Phase Resistance: 0.9ohms
* Inductance: 2.5mH+/-20%(1KHz)
Physical Specification:
* Frame Size: 57 x 57mm
* Body Length: 56mm
* Shaft Diameter: 6.35mm
* Shaft Length: 21mm
* Number of Leads: 4
* Lead Length: 500mm
* Weight: 700g
Connection:
Black(A+), Green(A-), Red(B+), Blue(B-)
Warning:
Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor.
daniel
Reviewed in the United States on March 27, 2024
So the purchase was easy and they product was what it said it was, the only issue was one motor had bad bearing. So we agreed to return it which was very easy and paid for! The only issue was we agreed on replacing items and the next thing I was reimbursed, which isn’t a bad thing I was just ( HEADLINE)! I’d purchase from them again anytime!
G. MCDONOUGH
Reviewed in the United States on December 17, 2024
So far, these fit my bill precisely. I needed some strong steppers with enough torque to get through occasional bumps and hesitations in my mechanical system. The system is not yet complete, but these clearly fit the bill.
doug richmond
Reviewed in the United States on July 7, 2023
Half of the motors needed the wires to be switched to industry standards. One box of five motors will have two or three wired differently. That causes a lot of unneeded troubleshooting. Normally switching the middle two wires works fine but what a nightmare when you need to replace a failed unit and you have to go back and rewire for each step motor.
Ian
Reviewed in the United States on January 22, 2023
Shipping was impeccable. Product , as described.
Shrubery
Reviewed in the United States on April 29, 2021
Each work well. High torque both running and holding.
Heather
Reviewed in the United States on January 14, 2020
These steppers are awesome! They hold their torque at high speeds really well, and have driven my CNC fantastically under very rapid speeds and heavy spindle loads.
Family Account
Reviewed in the United States on December 27, 2017
Excellent, as described. Packaged great. Survived shipping person throwing it over the gate.
Dennisa95
Reviewed in the United States on December 2, 2016
They are a little smaller than expected but well built
Recommended Products
$63.00
$ 25 .99 $25.99