Your cart is empty.
Your cart is empty.No doubt, the strongest impact socket line around. Sunex Tools impact sockets tackle the toughest jobs with a chrome molybdenum alloy steel grip that won't let go. With solid durability that keeps them driving through job after job, we've got sizes and styles enough to fulfill any need.
Joe B
Reviewed in the United States on March 17, 2025
Mine came with a white plastic insert, which caused socket to not grip properly. Remember to remove plastic insert before use.
Large1
Reviewed in the United States on March 10, 2025
Super slim fit right in my hot water heater sleeve
Richard
Reviewed in Canada on February 4, 2025
Perfect for removing anode rod from water heater.
Thomas Liu
Reviewed in the United States on January 8, 2025
Like others said, it took awhile to find one that fit the water heater opening! I was worried about the thinness but it’s actually quite durable.
Customer
Reviewed in the United States on January 15, 2025
White sleeve pulls off to make getting the rod out easy. Perfect
Write Way
Reviewed in Canada on May 2, 2024
Why the hell did Rheem make it so hard to find something to fit the hole for the sacrificial rod? This fits my 40gallon unit.Thank you to the poster who put this message in their review.
Anonomys
Reviewed in the United States on December 17, 2024
Heard about this socket from another site, specifically bought to remove my old anode rod from my water heater. The standard impact sockets were too thick to completely slide down over the anode rod. Just remove the plastic sleeve with pliers.
Harley UltraRider-NC
Reviewed in the United States on December 16, 2024
1 1/16" is very close to 27mm and can be used interchangeably
Chem Girl
Reviewed in the United States on October 24, 2024
The other reviews were spot on. This socket fits the anode on a RHEEM water heater without having to remove the plastic cap around the anode. None of my other impact sockets would fit because they were not thin walled.
BB User
Reviewed in the United States on October 12, 2024
While the socket is the correct size, the way Rheem hybrid water heaters are made, this is still too thick to fit without removing a lot of the plastic surrounding the nut (even if you remove the white outer housing from the socket). Since you have to remove the plastic surrounding the nut, any 1 1/16 socket will do.
ANTOINE
Reviewed in Canada on April 25, 2024
Short of turning down a deep impact socket on a lathe, assuming you have all that, this is the ONLY deep socket I have found that actually fits and reaches the anode in my hot water tank. After preparing the tank for this job, just slip out the socket's white plastic protective liner and use a short burst from a 1/2" impact gun to loosen it, carefully finishing the removal by hand so as not to drop additional anode material in the tank.The socket is thin and tough enough to do the job.None of my other deep sockets worked.
Recommended Products
