Your cart is empty.
Your cart is empty.From the Manufacturer
This Sunex 3/4-inch drive x 2-1/8-inch impact socket will give you years of usage. It comes with a lifetime warranty which backs the craftsmanship of this CR-MO alloy steel product. It will meet your needs and is at a great value.
Lex
Reviewed in the United States on March 17, 2025
Works excellent!
R. C.
Reviewed in the United States on June 18, 2024
Did what I needed
john Kwasniewicz
Reviewed in the United States on September 2, 2023
Worked as advertised.
jeff carter
Reviewed in the United States on February 21, 2023
Just what I needed for my work
Glen
Reviewed in Canada on January 20, 2023
Well made. Only needed for removing front hub nut on a heavy truck but worth having on hand. Item was received quickly without problems. Will definitely continue shopping Amazon.
Leo
Reviewed in the United States on December 28, 2022
In fairness, one of the most important aspects of a tool purchase is it's ability to stand up to wear and tear over time. That said, I'm going to give my opinion based on limited usage over a few months.This is one of two sockets I needed, so I'm leaving the same review for both. I needed to get the end off of a cylinder and normal socket sets just weren't large enough. I bought this socket for use with an impact drill because a large wrench just wouldn't do the job, not even with my full weight hanging from it. I was very happy with this socket's ability to get the job done. Granted, the impact drill did most of the hard work, but the socket held up to a tough job. In addition, I found that the sizing of the socket was accurate.In the end the socket did exactly what it was designed to do, and held up to tough job. I'll update this review if the socket fails at some point.
Yipster
Reviewed in the United States on October 24, 2022
Bought to remove a hydraulic cylinder nut. Worked like a champ. Wish the inside depth was slightly more.
Vintner Don
Reviewed in the United States on July 14, 2017
Used this for the clutch nut on my Burgman 400. The socket didn't fit right. I ended up using a Dremel to grind the sides a bit to have it fit the nut. Once it fit, it was fine. Nut is supposed to be 54mm, so it should have fit fine. So, if getting for your Burgman, either go a size up or modify as I did.
Sean E. Cantrell
Reviewed in the United States on November 12, 2017
I bought this to use on the hubs of my Toyota Land Cruiser and it does not work. The product itself is great and appears to be of good quality. If you are trying to use these to tighten the nuts inside your hubs it will be too thick.
Recommended Products
