Your cart is empty.
Your cart is empty.Product Description
Richard Moore
Reviewed in the United States on February 6, 2025
4 years and 1500 miles and i am installing new bushings and sleeves. Dont waste your money on these.
wezzz
Reviewed in the United States on September 5, 2023
When installing these, you should know that the bushings are NOT all the same. They have different shoulder thicknesses. So I got 90% of the way through the install and realized I had to redo a ton of them. They are packaged in a way that vaguely attempts to tell you which ones go where, but the labeling is often hard to determine which bushings go with which label, and they are all labeled things that you might not know what they are.They are good quality, but a small amount of additional effort would have given these 5 stars instead of 3.
Customer
Reviewed in Canada on August 12, 2022
All of the bushings are too short. Only the steel sleaves are useful.
Steve Anton
Reviewed in the United States on November 10, 2021
Have not yet installed, but pleased with quaity of these replacement bushings. Plan to install for upcoming season to regain that new handling feeling back. Pleased with this very complete bushing kit.
Clayton C.
Reviewed in Canada on October 30, 2021
As described Easy install
Mike
Reviewed in the United States on June 9, 2020
I don't have that many miles on them but they seem to work good so far. I installed them on my rzr 4 800 2013. There was some labor involved getting the old bushings out. I found that using a garage door spring tighten rod then putting that rod in between the two old bushings on the inside edge tapping with a hammer made it easy getting the old bushings out. That method didn't work for the lower back a arms. For that I had to use a flat head screw driver and vise grips to grab the plastic bushing edge and pull it out. I believe all the bolts for the arms were 15mm. The grease I used was Lucus marine grease. It had a high temp rating and was excellent for water. People use it for boat trailer bearings all the time.
Rach735
Reviewed in the United States on May 12, 2020
Perfect fit and finish for my 2010 800S, took care of all my worn out bushings and tightened things up.
chris gregersen
Reviewed in the United States on December 30, 2020
I gave it 2 stars for easy to install. They were easy to install, it was getting the old ones out that was fun. Lol. Make sure you grease them good because some of the places they go don’t have grease fittings. Also now would be a good time to grease the hub bearings.
Customer
Reviewed in the United States on August 5, 2019
These fit perfect on my 14 RZR S 800, and were easy to install. Instructions were not the best but I got it figured out after looking all the parts over closer.
Dean Theel
Reviewed in the United States on February 20, 2019
Fit perfect
Recommended Products