Your cart is empty.
Your cart is empty.Barbara Crow
Reviewed in the United States on September 6, 2022
Raised the front of my 1995 Jeep Grand Cherokee 3/4" I just ordered another set and later will order a set for the rear springs. Like someone else stated drill a hole through them and zip tie to the springs they rest on. Use stainless steel zip ties not plastic so the spacer never falls out.
Demetrio
Reviewed in the United States on July 2, 2022
It actually worked and there still on there! LolI drilled holes to accommodate 2 zip ties for each spacer....one for the top spring and one for the bottom spring on each spacer.The holes i drilled on spacers were a little under a 1/4 inch.If the spaces between your springs are less than 3/4 of an inch .....the spacers are going to be a little harder to twist in.....and I'm talking setting the spacers on the high setting to get the full 1 1/2 height.
Jason B.
Reviewed in Canada on January 19, 2022
These things work pretty well especially for the price. I used them in my ATV for bumping up spring rate for a snow plow. Would definitely recommend.
Anthony Gary
Reviewed in the United States on January 13, 2022
These lifters gave me at least an inch and a half on my front end. Also it feels it's more stable going over bumps and potholes. They are a bit to install in because of the tightness of the springs but overall they did the job.
J Bolt
Reviewed in the United States on December 22, 2020
The fit perfectly but with installation the wheel and tire has to come off.
C. T. O.
Reviewed in the United States on May 7, 2016
These work fine. Be aware that if you jack up your vehicle body allowing the axle and tires to hang free during a repair job or at a car shop, the springs will stretch and the spacers will fall out. I wish they were molded with a slot for the spring to clip onto so it would stay in place until the spring compressed back to normal.
Customer
Reviewed in the United States on March 28, 2016
They showed on your web site that they would fit a 64 GTO but they are to small you need larger ones please change your web site to fit the right application on 64 GTO I wasted my money on this product.
Robert B.
Reviewed in the United States on August 19, 2015
Did not fit my Chrysler Pacifica rear coil springs
Randy O. Soulliere
Reviewed in Canada on May 10, 2015
they fell out after 1 week of usage
joe f
Reviewed in the United States on May 27, 2014
they worked when i needed to esp in long trips ..they fit was very suprised.sometimes its off on the fit guide
Recommended Products
![A-Premium 2Pcs Rear Suspension Coil Spring Set [4WD] Compatible with Toyota FJ Cruiser 2007-2014 4.0L, Constant Rate Spring, Driver and Passenger Side, Replace# 4823135321, 4823135420](images/loading.gif)