Your cart is empty.
Your cart is empty.Product Description
Made of brass material, sturdy, corrosion resistant, could be used for a long time.
Comes with a cap, threaded tire core valve and brass body.
Maximum working pressure is 150PSI.
Temperatures range from -65 to 250 degrees Fahrenheit.
We would appreciate you letting us know of any problems.
We provide BEST service
Burm Buster
Reviewed in the United States on March 10, 2025
Great product.
Mike G
Reviewed in the United States on January 20, 2025
I installed one of these on the drip tank on a gas well to easily monitor pressure without having to leave a gauge installed. No leaks and makes pressure checks a snap using a digital gauge.
Blake
Reviewed in the United States on January 13, 2025
Works
K M.
Reviewed in the United States on September 24, 2024
These findings worded great, good quality.
L J Blasko
Reviewed in the United States on June 24, 2024
I liked this product. It is well made.
Horton L. Taylor
Reviewed in the United States on November 10, 2024
Everything was fine
Scott E
Reviewed in the United States on January 8, 2024
I bought an clip-on type adapter for my Dewalt high/low-pressure inflator because, like everyone else, I was getting tired of screwing on and off the hose. My adapter came and it wouldn't work because it had a 1/4 inch female opening and I needed the smaller one. Enter this little piece of equipment. It has a valve on the small end of it and the exact right size on the bigger end. Because of the valve, i didn't think it wold work. I put it on anyway and was surprised. It works with those inflators. So if you get the stand-alone adapter you'll need to buy one of these. If you get the adapter that comes as a 6-inch long hose with a male end already, you won't need this.
J_Fish
Reviewed in the United States on December 22, 2023
These work exactly as they should and the npt threaded side is a legitimate, full length npt thread. Anyone familiar with cheap threaded pipe fittings online will know that a lot of those fittings come with a truncated threaded portions that aren't long enough to form a good seal and end up bottoming out before any torques is applied. These are not like that, there is plenty of thread to thread into even a worn female fitting and tighten with several revolutions of thread remaining outside of the joint. I've only pressurized these to aplbout 160psi and had absolutely no issues so I'm sure they are good for much more than that.
Recommended Products