Your cart is empty.
Your cart is empty.Sierra 18-7945 10 Micron Fuel Water Separating Filter for Mercury/MerCruiser and Yamaha DETAILS Sierra Fuel Water Separators Remove over 99. 8% of Emulsified Water from your Gasoline Over 90% Efficient at Removing Particles as small as 10 Micron AND Flow at 90 GPH to Feed even the Hungriest Motor Sierra 10 Micron Filters are Recommended to prevent Damage to Sensitive Inboard, Sterndrive and Outboard Fuel Injection Systems Replaces: Mercury/MerCruiser 35-802893Q01, 35-604941, 35-60494, 35-55501, 35-57250, 35-60494A5, 35-806771, 35-8052691, 35-802893Q, 35-807172 and Yamaha ABB-FUELF-IL-TR Filter Size: Long - 4. 35" or 110. 5mm Rating: 10 Micron Flow: 90 GPH ABOUT SIERRA Sierra is dedicated to protecting you and your investment. For 50 years Sierra, one of the most trusted names in the marine industry, has proudly been offering high quality engine and drive parts. Their products meet or exceed the original equipment part it replaces and are engineered to meet today's high horsepower engine demands while withstanding the harsh marine environment. SIERRA'S CUSTOMER SATISFACTION All Sierra parts qualify for Sierra's Industry Leading Customer Satisfaction . Sierra warrants its products to be free of defects in workmanship and materials for the useful life of the product. If a Sierra product fails to comply with the , Sierra will repair or replace the defective product free of charge. The is subject to additional terms, conditions and limitations. You can view Sierra's full located above in the Technical Specification Section.
gillou
Reviewed in France on March 3, 2025
ras
Customer
Reviewed in the United States on September 12, 2024
It’s a filter
Bryan
Reviewed in Canada on June 22, 2024
Ethanol in gasoline absorbs moisture from the air causing issues for starting and carburetors. This filter stops water and dirt from entering the carburetor causing damage and starting issues. This is the third one I’ve installed in the equipment I own. Most fuel in Ontario Canada has ethanol in it doesn’t matter what grade so do you’re self a favour and head off damage and break downs install one today.
ANDREW LEE WALSWORTH
Reviewed in the United States on May 18, 2024
Used this on a vmax 225, fit perfectly.
MV
Reviewed in the United States on October 21, 2024
I've been using this filter for years and then never have had any problems
Customer
Reviewed in the United States on April 17, 2024
This is a 10 micron filter, filters smaller particles than mercruiser. I have been using these for over a decade.
Kunde
Reviewed in Germany on April 10, 2024
Top. Passt. Schnelle Lieferung
Customer
Reviewed in Canada on July 3, 2023
Had to return as it is 1/4” deeper than Mercruiser equalivalent. Would not fit in my boat
Chuck
Reviewed in Canada on December 1, 2023
As advertised. Thank you for the quick service.
Zachary S Roberts
Reviewed in the United States on May 12, 2022
Used on a 1985 Chris Craft Scorpion 210 with the 5.7 Mercruiser 260. I had a cut-out problem when I hit 3000 rpm and the boat would fall on its face. I replaced this and the metal screen filter going into the Quadrajet and all is well at the higher rpms. I have purchased Mercruiser fuel filters in the past also and I actually prefer these. But that's just from my experience. Make sure you stretch, in my experience the rubber seal on these practically bond to the fuel filter housing, especially if they were put on too tight.
Michael Richards
Reviewed in the United States on January 14, 2019
I purchased this product to use in my Diesel engine Truck. Even though the manufacture suggest its use on only Gasoline systems, I decided to give it a try. I have had it on my Toyota truck for the last two years, and it has worked perfectly with the first (supplied) filter still in use.In my country the diesel fuel out of the service station is very dirty, and most diesel truck owners regularly have to change their OEM filters (expensive). I placed this filter in line before the OEM filter, and since then have not had the need to replace the OEM filter, something I had to do previously every three months to avoid engine running problems.I would recommend this filter to everyone who wants trouble free running.
SharpSeaz
Reviewed in the United States on August 4, 2013
I have been using the Teleflex 10 Micron fuel filters for five years on both my Yamaha F115 and a pair of F200. I have also used these filters on a 2006 Yamaha F150. These are a great substitute when considering the rather pricy OEM (MAR-MINIF-IL-TR) for the F115, and the (MAR-FUELF-IL-TR) on the F200.I replace these every 100 hours on schedule and check them for trapped water, contamination or phase separation in the fuel. Without question I have concluded that these fuel filter water separators to a great job at removing debris and water from the fuel before it reaches the engine fuel filter.The quality and construction are also up to par and not prone to rusting at the mounting plate unlike the Racor product that are cheaply packaged (no box and torn shrink wrap) and can be found rusting right there on the store shelves.
Russ H.
Reviewed in the United States on May 7, 2013
I admit it... I'm a chronic overtightener!I bought this filter for my boat for this year's fishing season. I like to minimize the things that can cause my old Mercury Thunderbolt 850 from running rough. Had a REALLY tough time getting the old filter off. Even tried the screwdriver through the filter trick and just shredded the old one. But I eventually got it removed.This filter seems to do it's job well. I've got a fresh tank of stabilized gas, this filter, and a new primer bulb. The first fishing trip of the year was a great success! The old girl purred like a kitten!I highly recommend a good quality Fuel Water Separator to be installed in your fuel line. Takes at least one variable (water) out of the equation if you have a rough running outboard!
Recommended Products
