Your cart is empty.
Your cart is empty.Michael Gill
Reviewed in the United States on February 6, 2025
Very happy with this product. I waited for a warm day to apply them and the decals went on perfectly. The decals went from the door edge on one side and under the rubber molding on the other. The texture perfectly matches my steps and the OEM bed cover on my ‘20 Tacoma.
kim jeric
Reviewed in the United States on January 9, 2025
This is a good product it was easy to install.
Irvin
Reviewed in the United States on January 19, 2025
Took a long time to ship but other than that its a good product fit as should. I was tired of seeing the faded oem piller lets see how long it will last with the 3m adhesive.
Josh L
Reviewed in the United States on July 16, 2024
5 month update (Jan. 2025):The vinyl began coming up in the past month and looks terrible. I followed all prep instructions but didn't seem to matter as 3 out of the 4 are coming up at the edges. Wondering if the AZ heat was too much for it to handle. Either way, $50 down the drain 👎🏻. Wouldn't purchase again.Original review from July 2024: I would echo what others have said in that the quality of the material is great but the fit is tight. If you were to remove the original vinyl the coverage would not be ideal and you would see that the decal is slightly skinnier than the original vinyl. My suggestion is to leave the original vinyl on the pillars and apply this over the top of the vinyl to get a cleaner application/lookAll in all in satisfied and the install was easy with the assistance of a trim tool to help peal back the window seals slightly to get the vinyl applied behind the seals.
STEVEARENO
Reviewed in the United States on July 10, 2024
They seem to be good quality. They don't come with instructions, but I just went right over the stock black decals. I learned it was easiest to start in the upper right angled corner and work my way down, then lifting the rubber trim and pushing the decal under.
Cecil Brockman
Reviewed in the United States on March 3, 2024
Good product to overlay on your existing blackout tapes (as specified in the fine print). But not an actual replacement as the product description says. Bought these to replace mine after removing OE tapes to paint. Way to small to reach edge of glass run Chanel, leaves a gap of visible paint in between even if laid flush on the edge of door jamb. My fault for not reading more of the product description, hope this review helps someone else avoid the same mistake!
Nick
Reviewed in the United States on October 17, 2024
Read the description carefully. This is a great product and very easy to install. I highly suggest it but if you have a Tacoma model that does not come with B-pillar vinyl from the factory then this is an overlay and the paint from the truck will show. Makes it look bad. Knowing this I bought some vinyl wrap and I measured the area. I was about to lay it but my measurements were slightly off and wrapping that curve at the top is more difficult than it looks. I wrapped my roof and tailgate and kept messing up that one part at the top of the b-pillar. So I decided to install the overlays, then tape them off and used plasti-dip to color match the vinyl. It looks great and to those that have them installed and the paint from their truck is showing. Go ahead and get some black plasti dip and fill it in. If you don’t like it then it peels right off but trust me it will look good.
Kerry Gordon
Reviewed in the United States on December 25, 2023
Hands down the best and easiest upgrade I’ve applied! Looks great and I love the texture.I rarely write reviews and never post pictures, but this skin remedied a sun faded eyesore I’ve been frustrated with for a while.The installation is simple:*Clean surface with alcohol*Carefully line up and skin.* Apply slowly! Simple and ZERO bubbles to deal with. If it’s not perfectly lined up, just pull it back a bit until you get it right.I’m writing instructions because none came with the skins.I emailed TufSkinz and they immediately responded with instructions on how to apply.I did it over the existing vinyl and it adhered perfectly. Took about 30 minutes to do the job.No frustrating soap and water to deal with.Many thanks to this company for making a great, unique product.I’m a customer of TufSkinz for life!!!
Recommended Products