Your cart is empty.
Your cart is empty.Product Description
Jonyboy
Reviewed in the United States on March 5, 2025
Fit with no issues. Would buy again and keeps temps nice and stable.
Siorus
Reviewed in the United States on March 24, 2025
These are fine heatsinks and they're well-made, but the thermal pads are too thin for some drives.I have a Kingston NV3 with a Phison controller, and the z-height of the controller chip is so much lower than the flash that the stock thermal pad cannot make contact with the controller at all. Obviously, this somewhat defeats the purpose of the heatsink.I was able to resolve the issue with thicker pads of course, and otherwise the heatsink is fine.It will easily outperform the various lightweight aluminum extrusions you can buy on Amazon--the ones that are held on with little wire clips or silicone rubber bands that sell in two or four packs for about what this thing costs--due to thermal mass and the flatness of the base alone.It doesn't have the fin area to match the performance of the larger Thermalright heatsinks with heatpipes and thin aluminum fin stacks in use cases where the drive is under high load for tens of minutes at a time, especially with a pcie 5.0 ssd, but that's a highly unusual use case and for most people the difference will be immaterial.If Thermalright had included thicker pads by default or as an extra in the box it'd rate 5 stars, but the thermal pad issue knocks it down to 3.
Customer
Reviewed in the United States on March 20, 2025
Easy application and decent results. Noticed my SSD was running a bit hot so I figured why not spend a little to extend its life. You may want to re-arrange the compound between the heat sink and your SSD, mine didn't seem to contact perfectly at first. Good value item for the peace of mind that my SSD is running a bit cooler.
Lisa Siwek
Reviewed in the United States on February 27, 2025
The media could not be loaded.
Chris
Reviewed in the United States on January 2, 2025
Drops the temps, good price. Crucial p5 runs uncomfortably hot on PCIe gen 5 even though it is a gen 4 SSD. Moving slots increased it's speed a little I thinkk but temps jumped up to around 80c. Now with a heatsink it stays below 70 again. I have a micro atx case with not very much ventilation.
BFZ
Reviewed in the United Arab Emirates on June 1, 2024
Reduced the temps on my ssd by 25C under load (80C to 55C). And will fit even if the slot is under the GPU.If you are facing temps issues do not hesitate to Buy
George V
Reviewed in the United States on May 25, 2024
Before you install make sure your SSD will make contact with all of the thermal pad's surface. If both sides of the SSD are not in contact then you will loose efficiency in the heat wicking. When both sides are not in contact then you will have to do some DIY. What I did for both my WD SN850x and Samsung 970 Evo Plus is cut the half of the thermal pad that is not big enough out of the heatsink and cut out a 1mm thermal pad in its place. If you don't get what I am saying, checkout the guide "Stop your Samsung NVMe SSD from overheating and Thermal Throttling" by Electronics&Computers on YT. It is a short guide that gets to the point on it.
Paul
Reviewed in the United States on October 31, 2024
I did a lot of searching and researching before I chose this Heatsink, it was very easy to install. Esthetically looks clean and nice.
Ken
Reviewed in the United States on April 4, 2024
I was looking for a cheap SSD cooler for my PS5 and this one comes out to be one of the cheapest choices. However, the build quality is much better than some of the pricy ones and it works great.
Rodrigo Mercado
Reviewed in Mexico on September 1, 2023
Este disipador baja al menos 10c la temperatura, considerando que en mi caso tengo ventilador de aire en la parte lateral del gabinete de mi PC el cual extrae aire y parece hacer buen trabajo manteniendo a raya el SSD M.2. Las imágenes perteneces a unas pruebas que hice con un SSD m.2 NVMe Teamgroup MP34, el cual fue la causa de que comprara este disipador para estrenar ambos a la vez. La temperatura ambiente en el momento que hice los test promediaba de 25 a 27c, el M.2 en cuestión con temperatura inicial en reposo de 37c, teniendo como base de comparación un SSD secundario Toshiba TR200 el cual tenia 31c de temperatura en el momento de realizar las pruebas *y ese SSD es incluso más frio que muchos HDD convencionales.—Lean los textos que agregue en cada imagen para comprender el contexto
Recommended Products
$16.90
$ 6 .99 $6.99
$13.49
$ 6 .99 $6.99