Shopping Cart

Your cart is empty.

Your cart is empty.

Throttle Response Controller Compatible for 2023 2024 2025 Chevy Colorado 2023 2024 2025GMC Canyon (2023-Newer) Accessories Wind Booster Chevy Colorado 9 drive Fuel Throttle Pedal Response Controller

5.0 Write Review
Free shipping on orders over $29.99

$199.00

$ 94 .99 $94.99

In Stock
  • 【Use for】The pedal accelerator is an electronic machine that works as throttle response controller system remove the delay from your electronic gas pedal, allowing your car to accelerate faster, gas saving and improve efficiency. It is one of the most effective and useful of the many power boosting accessories.
  • 【Fits for】Throttle Controller fits for 2023 2024 Chevy Colorado 2023 2024 GMC Canyon,Before purchasing,Confirm the Pedal connecter is same as our sec picture. It can turn your lazy 2023 2024 Colorado GMC Canyon into a fierce beast and give you new driving experience.
  • 【What Funtions it has】This electronic throttle response has 6 driving modes, Normal, Econ, Sports, Super Sport, Race, i-Auto, each with 9 adjustable gears to give you precise power adjustment. If you are tired of the current 2023+ Chevy Colorado 2023 GMC Canyon Wind Booster can make it live again.
  • 【INSTALLATION GUIDE】Throttle Accelerator includes detailed installation instructions, direct plug and plays the throttle Controller with the vehicle off,takes about 5 minutes to install.
  • 【Warranty】 It will not leave any information in the ECU and will not affect your car warranty. When you install it there are error codes appearing on the dashboard, you can refer to our details page to fix the problem. Or you can contact us and we go to provide.


Ensure your car's pedal connector same as the second picture.


This Throttle Response Controller suit for :

2023 Chevy Colorado （2023-Newer)

2023 GMC Canyon （2023-Newer)


Installation steps and precautions: (Please install after the car is turned off)

1.Pull away the interface of the accelerator pedal;

2.Connect the throttle controller cable plug with accelerator pedal interface;

3.Tear the protection paper on the back of Throttle Controller, and stick it on the central console Safety Cautions.


How to solve engine garbled code after installation?

1. Remove the wind booster, and connect the original cable

2. Cut the negative power supply of the vehicle battery (about 5 minutes), and then connect the power supply to check whether the fault code has been cleared.

3. If the fault code has been cleared, cut the power again, and reinstall the wind booster in the state of stopping the engine and turning off the power.

4. After it is completed, connect the power again.


After finish installation, please start engine under the Neutral or P Gear, check the accelerator pedal is work.

Please feel free to contact us if you have any questions during use, we will solve it for you, thank you!