Shopping Cart

Your cart is empty.

Your cart is empty.

Trend CraftPro Straight Two Flute Router Bit, 1/2 Inch Shank, 25/32 Inch Cut Diameter & 1 29/64 Inch Cut Length, Tungsten Carbide Tipped, C030DX1/2TC

4.9 (6) Write Review
Free shipping on orders over $29.99

$43.79

$ 20 .99 $20.99

In Stock

About this item

  • VERSATILE 2-FLUTE STRAIGHT CUTTERS: Designed for multiple routing tasks like edge trimming, grooving, and rebating; delivers high-quality finishes at slower feed speeds due to limited waste clearance.
  • TUNGSTEN CARBIDE TIPPED: 5/64 inch micro-granular extra-hard tips for prolonged sharpness and cutter durability. Ideal for cutting softwood, hardwood, and man-made timber boards.
  • PTFE NON-STICK COATING: Its PTFE non-stick coating reduces friction, minimizes resin build-up and extends the cutter's lifespan for uninterrupted router performance.
  • PRECISION CUTTING: The highly ground tip face is polished to 800-grit to ensure accurate cutting with a fine finish for professional routing results.
  • SAFETY & COMPATIBILITY: Longer shanks accommodate both handheld and table routers. Features a Safety K-Mark for optimal shank positioning. EN Shank Markings for visible cutter safety data.


Trend Craft Pro 1/2" Shank Straight Router Cutter Bit-Ref, C030DX1/2TC Diameter 20mm Cutting Length 50mm Tungsten Carbide Tipped, Shank 1/2 inch x Dia 20 mm x Cut 37 mm


Stephen Collingswood
Reviewed in the United Kingdom on January 6, 2025
Trend have never let me down when buying tools and this was no exception - flawless bit and super sharp.
Customer
Reviewed in the United Kingdom on September 18, 2024
Very good product
Alex H
Reviewed in the United Kingdom on December 3, 2023
There is certainly cheaper router bits on the market. BUT with Trend you get a quality router bit every time and they last longer too.
Tate
Reviewed in the United States on April 29, 2023
I tried several different 20mm router bits and forstner bits and most were not good, and left burn marks and generated WAY too much heat. If you’re attempting to make your own MFT top then I implore you to stop looking for a bit and buy this router bit.This was about my 4 different router bit that I purchased for my MFT table. The reasoning was that I thought shipping from the UK would take weeks and would cost a boat load. I was wrong about all of that. I had this bit within about 10 days.The holes were very clean, it didn’t burn any holes (I did around 80 dog holes on first use), and the bit measured exactly 20.00mm on my caliper. In the future I will probably buy other Trend router bits because this one cut so smoothly.
Mark
Reviewed in Australia on July 22, 2022
Holes too big for Benchdogs UK 20mm dogs. Cuts slightly larger than 20mm. Sharp and clean ……just too big for that particular purpose.
Morgan James
Reviewed in Australia on December 25, 2022
Bored mft holes nicely. Also used for some machining of grooves. Cleans up nicely between uses and still sharp after few hrs of use.Bench dogs fit nicely. Haven't made exact measurements of holes and dogs yet.Small gripe but wish it came in better packaging like CMT bits do...