Your cart is empty.
Your cart is empty.Screw-on (Threaded Pattern) brass guide bush with locking ring. 1-3/16 inch (30 mm).
k
Reviewed in Canada on September 4, 2024
For some reason these are really hard to find in any local stores, or online. The price is a bit higher than expected, but it did the job and fit my jig and router, so I was able to get the job done.
Allen B Sowinski
Reviewed in the United States on May 10, 2024
I needed this odd size router guide bushing for a project & it had to fit my Porter Cable router base. It fit my router perfectly & functioned very well. The only difference was the thread size on the locking ring. But since I plan to keep the locking ring on the guide busing in storage, it will never get mixed up with the genuine PC guide bushing rings.
Mr. G. Cusick
Reviewed in the United Kingdom on April 23, 2024
I bought one of these to supplement a set of Katsu threaded bushes - I needed a second 30mm bush. I have sub-bases on my routers that are threaded to accept the Katsu/Leigh/Porter-Cable bushes without the need for the separate lock ring.The Trend bush has the same diameter thread, but for some reason that I can’t fathom, has a different pitch. So it will not screw into my router bases.Returned for refund - no trouble at all, thanks Amazon.But who in Trend had the bright idea of using a different thread from the rest of the industry?
TRickman
Reviewed in the United States on November 19, 2022
Need it to cut holes for a MFT table. Did the trick.
reel busy
Reviewed in the United States on February 12, 2019
This does work great with the dominofix jig. Problem at least on the bosch router is with the festool 20mm bit, this bushing limits the depth of the plunge ie the collet will bump into this, due to the short shank of the router bit you can only have about 1/4 inch of the festool bit in the router. It worked perfect (be sure to use a centering cone for the entire setup) but not ideal for sure. Not the bushings fault it worked great, just putting it here as an FYI.Followup on the dominofix jig, i would not recommend using this bushing. Not knocking the jig it's very well made however these type jigs can suffer from compounding errors. Bosch router + bushing + short shanking the bit is a lot of additional things (even when centering the bit) to introduce a slight error which can compound. Lots less compounded error chance if you used a festool router. I was a bit off over 4 or 5 feet however it wasn't an ideal setup due to using all of the adaptors (who knows could have also been my surface i was routing had some flex too). It will work fine just a pain in the rear compared to using the festool router.
Jean Galbraith
Reviewed in the United States on January 7, 2019
Works perfect. Using with craftsman router and Domino FX jig
Recommended Products
$39.90
$ 16 .99 $16.99