Shopping Cart

Your cart is empty.

Your cart is empty.

TRIPPER Mobile Phone NFC Control Board Fingerprint IC Card DIY Relay Module 13.56Mhz Access Control Card Controller, IC+NFC

5.0 Write Review
Free shipping on orders over $29.99

$20.91

$ 9 .99 $9.99

In Stock
  • 4. In the jog mode, the output time can be adjusted, and the output can be up to 15 minutes;
  • 3. Three control modes can be switched: jog mode, self-locking mode, ignition mode;
  • 1. Compatible with DC12V-24V voltage range;
  • 2. Three verification methods: fingerprint, IC card, mobile phone NFC
  • 5. With relay normally open and normally closed output control.


TRIPPER 6. IC card/NFC sensing distance: equal 25mm
7. can be connected to the exit button
Three control modes:
Inching mode: turn on after fingerprint recognition; automatically turn off after releasing the finger and reaching the set delay time.
Self-locking mode: turn on after recognizing the fingerprint; after releasing the finger, it will be disconnected immediately after re-identifying the fingerprint.
Ignition mode: keep the fingerprint recognition unreleased; it will keep on all the time, and it will disconnect immediately after releasing the finger.
type:IC+NFC
Colour:black
Material:plastic+metal
Package Contents:
1 x Control board with shell
1 x induction antenna
1 x management card
3 x user card
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.