Your cart is empty.
Your cart is empty.Curt
Reviewed in the United States on February 24, 2025
Like reported the knob is off 90° and the shaft is longer. I used a small screwdriver to pry the sides open on both new and old switches and removed new shaft and replaced with old one. Reassembled and squeezed tabs with larger channelock pliers and it works with knob aligned as it should be. I could have mounted the switch sideways as there are holes for screws but shaft would still have been too long.
yuen
Reviewed in the United States on January 31, 2025
the stem is too short for my range ,may be my range too old
D. P. Law
Reviewed in the United States on September 16, 2024
did not fit
David
Reviewed in the United States on September 16, 2024
works as it should
Yaggs
Reviewed in the United States on August 22, 2024
Everything was exactly as the original, with the exception of the mounting. It was 90% off. The wires are long enough to make the adjustment for installation. Its covered so only someone working on the stove will know.
Dan
Reviewed in the United States on November 23, 2024
dial is 45 degrees off now, otherwise ok.
Recommended Products