Your cart is empty.
Your cart is empty.Wera Tools 05072082001 855/1 Z PZ 2 X 25 MM BITS FOR POZIDRIV SCREWS
SLuGGLe
Reviewed in the United States on September 25, 2024
Wera last forever more than dewalt
Mark Klein
Reviewed in the United States on May 23, 2023
These bits fit the screws perfectly, and hold up even with an impact driver. Would buy again, but the ones I have will probably last longer than I will.
TCM
Reviewed in the United States on December 20, 2022
A must-have for the assembly of ikea sektion cabinets. My only regret is that I should have found one with a longer shaft—instead of this one that fits into a bit extension—so it would fit in tighter spaces.
srkandel
Reviewed in the United States on February 20, 2021
There's a very slight difference between phillips and pozi drive bits. Most cabinet hinges are pozi drive which is a slightly shallower angle than phillips drive.
apollinaire
Reviewed in the United States on May 27, 2020
I have examined these and compared them against other PZ2 bits in my toolbox. While these bits are well made, I really find that they are closer to standard Phillips pattern. -Will try another manufacturer next time.
Sabayon Linux User
Reviewed in the United States on September 7, 2019
There are now at least three different "cross point" drivers for fasteners. Phillips, Reed & Prince, and Pozidrive, are all similar, but not the same. On an easy twist, you may get away with using the wrong driver, but when the going is tough, you must have an exact match to avoid stripping the fastener, or damaging the tool. These bits worked perfectly with my #2 Pozidrive screws.
XTsallaD
Reviewed in the United States on September 26, 2018
These are extremely high quality screwdriver bits. I use a lot of PZ2 fasteners with my work and these bits have a really good fit and finish that provide a good level of toughness and durability for professional use. Excellent for IKEA furniture assembly as well. The 10 pack is a nice quantity for me to keep in my mobile installation kits so that there is always a fresh bit handy. These have a forged style manufacturing process for the tip and they are a consistent quality with a very tight tolerance fit to PoziDriv recesses. I plan to continue to purchase these in small bulk packs as needed. Wera’s sheet metal bits are tempered to a little more viscous flexibility at the tip so they do wear with use but they don’t shatter under load from impact drivers whether fastening wood or metal. The ‘Z’ notes this type of tempering and Wera’s ‘H’ bits are very hard for wood screwdriving and less wear on the blades. PZ recesses are recognizable by the four tick marks at the corners of what otherwise would look like a normal Phillips recess, I hope this review is helpful.
Douglas G. Matheson
Reviewed in the United States on February 28, 2015
seems good, I have not used it as I did not match up the size right
Recommended Products
