Your cart is empty.
Your cart is empty.3/8 inch OD x 12 inch corrugated lavatory or toilet supply riser adds the finishing touch to any installation. Trimmable end allows cutting to length for easier installation.The top portion attaches to water closet or sink, using different sized washers. Made from lead free brass and fully finished for exposed installation. Easier to bend, and is more forgiving than annealed copper tubing. Available in a variety of stylish finishes, this item is sure to complement your existing fixtures. Be sure to check out our other model styles and VISIT OUR WESTBRASS STOREFRONT for more Kitchen and Bath items to stylize your home with convenient functionality and beauty.
Michael Demkowicz
Reviewed in the United States on January 11, 2025
This might be ok for very slight bends but if the valve is close to the toilets tank threads it’s no good. I had the sliver braided supply there earlier and wanted to use the black supply line but as it bent it just flattened out at the bends and it leaked like hell where it went into the valve which had the 3/8ths compression ring. I ended up putting the silver supply line back which you see in the 2nd picture.
Dennis Dearborn
Reviewed in the United States on February 15, 2024
The large end is perfect. The small end is too small to fit a standard size shutoff.
E***AC
Reviewed in the United States on February 17, 2022
Missing 7/8" toilet ballcock cone washer,
Brian H
Reviewed in the United States on October 9, 2022
So I was weary of this based on the reviews I'd read prior to ordering. But gave it a try as I couldn't find anything even close locally. Was happily surprised when I bent it to meet my needs and the finish didn't flake at all. Not even in the creases where I thought could be the most susceptible. Although, I was very slow and deliberate with the bend.
Jason
Reviewed in the United States on March 15, 2020
For my first remodel I wasn’t super keen on all the fancy ways a toilet can be plumbed. Well I ended up buying a nickel 1/4 turn valve and wanted to do a hardline setup. But since this was first time I didn’t exactly leave myself a perfect setup when I did the drywall. Anyways, I found this line perfect! I was able to bend it slightly enough to make a beautiful hardline connection without using a braided line. The line does make noise while bending it, and I had to wrench the compression super tight but I was able to install without issue. Oh wait, minus the rubber piece that comes with the pipe, it’s garbage. Lucky the nut I ordered for this came with one. But I had to open that one up too for this pipe. Hope this helps!
Eric O.
Reviewed in the United States on September 22, 2017
did not come with, " 1/2 in. thread-on faucet cone and 7/8 in. toilet ballcock cone washers" as stated in description. Very disappointing. The tube is nice, but all you get is what you see in the picture. You are going to need your own Nut to be able to screw on.
Recommended Products
$31.52
$ 13 .99 $13.99