Your cart is empty.
Your cart is empty.
Specification:
● Material: Metal
Package contents:
● 1 × pressure reducing valve(6.5 cm × 14 cm)
● 1 × plastic hose
● 1 × connector
The usage steps are as follows:
1. Prepare tools and materials: You will need a pressure regulator, a cylinder, a pressure gauge (if the regulator does not have a built-in pressure gauge), and corresponding connecting pipes.
2. Check the equipment: Make sure the pressure regulator and connecting pipes are not damaged or leaking. If any problems are found, do not use the device
3. Connect the gas cylinder: Connect the cylinder to the pressure regulator. Make sure connections are tight to prevent gas leaks.
4. Adjust the pressure: If the pressure regulator has a built-in pressure gauge, you can adjust the pressure directly by looking at the pressure gauge. If there is no built-in pressure gauge, you can use an external pressure gauge attached to the regulator. As needed, adjust the pressure knob or valve to bring the pressure to the desired value.
Precautions:
1. Before using the pressure regulator, make sure you understand the relevant safety procedures and instructions for use.
2. During operation, be sure to wear appropriate personal protective equipment such as gloves and glasses to prevent accidental splashes or leaks.
3. When adjusting the pressure, operate carefully and avoid over-adjustment or sudden pressure release to avoid danger.
4. Regularly check the status of the pressure regulator and connecting pipes to ensure they are working properly and are not damaged or leaking.
MM
Reviewed in the United States on August 28, 2024
The brass connector that screws onto the dispenser is not the correct size and will not fit onto dispenser which basically makes product useless.
Astral
Reviewed in the United States on July 13, 2024
Horrible quality. When fully closed, still very slowly leaks gas out. It comes with a red cap that is maybe intended to close off the dispenser attachment, but even when on, it doesn’t seal. So you have to unscrew the regulator in between the filling of the charger canister.
Garak
Reviewed in the United States on December 17, 2024
Broke with 1 time use. Leaked out of the connection to the gauge. I thought that was what the extra (different sizes) gaskets were for. But no way that I could find to remove the gauge.
Brandon G
Reviewed in the United States on November 13, 2024
So I expected this to be more of an industrial standard, but I have to remember that this is for a whipped cream charging container. It absolutely works wonderfully. It is easy, however to bend the gauges from the main valve if you’re not careful if it falls over or anything like that so be aware of that but other than that, it’s awesome. Loads and loads of fun with it. Enjoy.
Recommended Products
