Your cart is empty.
Your cart is empty.Product Description
Good Material
Made of quality rubber, anti-corrosion, anti-rust and wear-resistant, long service life. Withstand extreme temperature changes(-40°F to +275°F) and resist cracking and leaking.
Good Workmanship
Completely sealed, precise connection without falling off. Direct replacement of the old or broken heater supply jumper hose.
Original Size
Manufactured according to the original size data, exactly match the car in the fitment table, directly replaced is feasible.
- 1.Remove the pressure cap from the radiator or coolant reservoir and place a bucket or drain pan under the radiator drain valve.
You’ll need a bucket or pan that holds at least two gallons of liquid.
- 2.Open the drain valve.
Allow the coolant to drain into the container, and then close the valve.
- 3.Remove the clamps at both ends of the hose.
Clamps are cheap so buy new ones. If you can’t remove them easily, cut them off.
- 4.Twist the hose to remove it, and use the container to catch the liquid that drains from it.
Be gentle when removing the hose. If you’re not careful, you could damage the radiator.
- 5.Clean the fittings.
Use any degreaser or just a damp clean rag to clean the fittings that the new hose will attach to.
- 6.Install the new hose.
Attach and clamp one end securely in place before you tackle the other end. Make sure the hose won’t interfere with any moving parts or touch the engine when it’s hot, and that the clamps are tight.
- 7.If the coolant that you drained is fairly new and your container was clean, pour the liquid back into the system; otherwise, refill the system with a 50/50 mix of fresh coolant and water.
Be sure to dispose of the old stuff safely.
- 8.Start the engine and add more water and coolant as the level in the radiator drops.
Don’t fill the radiator to the top of the neck or the coolant reservoir up to the “MAX” line until the thermostat opens. When the upper hose is hot, the thermostat has opened. Then it’s okay to top off the radiator or the reservoir.
- 9.Replace the pressure cap.
If your engine is the type that needs to be bled, do so now, following the instructions in the owner’s manual or service manual for your vehicle.
Arien Suarez
Reviewed in the United States on March 26, 2025
It was great for my jeep cherokee
Edgar Maldonado
Reviewed in the United States on August 4, 2024
The hose was a perfect fit and delivered as promised. Ty!
Angel
Reviewed in the United States on March 3, 2024
Bought it for my 2015 Chrysler 200. It fits, may not be as strong and other sturdy pipes, but for the cost it's worth it. I have one in my trunk as a spare Incase of anything. Tip, the way to make it snap easy is by lubricating with oil.
Perfect fit
Reviewed in the United States on February 12, 2024
Perfect fit, no problems
Riadh Bergueb
Reviewed in the United States on December 17, 2024
easy installation in my 2018 jeep cherokee latitude ... good quality for after market part
Tamika N Gross
Reviewed in the United States on October 24, 2024
Hose needed to replaced and of course Amazon (my best friend) had it. And it fit my truck perfectly.
Heydi B Lawrence
Reviewed in the United States on June 2, 2023
Great part no issues
Austin valdez
Reviewed in the United States on January 24, 2023
Took about 30 minutes to take out the old hose and instal this new one. It fits perfectly
Recommended Products