Your cart is empty.
Your cart is empty. Material: T6063-T6 Aluminum
Position: Front Fork
Installation: NOT include Instruction
Size: 49mm
Fitment:
Fit for Dyna Street Bob FXDB 2006-2017
Fit for Dyna Lowrider FXDL/FXDLS/FXLR 2006-2021
Fit for Dyna Super Glide FXD/FXDI/FXDI35 2006-2010
Fit for Dyna Super Glide Custom FXDC/FXDCI 2006-2014
Fit for Night Rod Special VRSCDX 2007-2011
Fit for V-Rod VRSCA / VRSCB / VRSCAW 2002-2010
Pachage includes: 1* Front Fork Brace with bolts
Paul Smith
Reviewed in the United States on March 27, 2023
Excellent product. shipped fast. unfortunately, was the incorrect part for my bike and did not fit. I have since ordered the correct one and hopefully all is well. Not all dyna's are the same, even though they boast the same forks diameter.
Customer
Reviewed in the United States on January 31, 2023
Same fork brace many websites are selling under their name and charging 50-70% more for. Literally. The . SameAfter doing research.Step 1. Jack the front end up until the tire is suspended.Step 2. Loosen front axle pinch bolts.Step 3. Blue loctite all your bolts for the fork brace.Step 4. Install center pieces together. They are groved and will slide together aligned. Torque bolts to 10 ft ibs/ 120 inch pounds.Step 5. Carefully slide it between the fork tubes. Yes you can do it put together. Be careful of your fenderStep 6. Install side clamps. You should have the fork brace just below the end of the dust cap on the forks. You’ll see the line. Torque side bolts to 10 ft ibs / 120 inch pounds again use blue loctite. Incrementally tighten the bolts on each side. Swap back and fourth until they both are at torque. You can make the sides completely even by taking your time.Step 7. Tighten your front axle pinch bolts. 12-15 ft ibs/ 144 inch pounds- 180 inch pounds. Torque the rear bolt completely before the front.Step 8. Lower the bike and go ride. Have fun stay safe.
Barry Lee Graham
Reviewed in the United States on May 19, 2022
Doesn't fit 49mm Dyna. Machining is poor. Unfortunately there is a reason it's so inexpensive.
Patrick w Duley
Reviewed in the United States on July 6, 2021
It's a great part for a killer price, I was for sure thinking I would take it out of the box and put it right into the trash because it was junk but I look at it and it is a nicely made product. I powder coated mine black and I trimmed it a lil because of my aftermarket dust covers and I was not trimming them for it to fit they was 5×'s the price then this. But if I had stock dust covers it would have went right on. I looked up a similar one to it but name brand just to see the instructions and it actually helped a lot because I would have never put it on the way the instructions said too. look them up... but all in all a great product for a killer price
Sean
Reviewed in the United States on May 27, 2021
Way better quality than I was expecting. I put this on my 2016 fxdls.
Levesque
Reviewed in Canada on May 2, 2021
Ok
Steve Braden
Reviewed in the United States on March 29, 2021
Good accurate machining
Budget builder.
Reviewed in the United States on October 5, 2021
While righting one side the popped out and stripped completely. Steel screws with fine threads into alluminum just dont work.
Recommended Products
