Your cart is empty.
Your cart is empty.Product Description
Motorcycle Fender Eliminator / Tail Tidy Kit
Condition: new (Aftermarket Product, Not OEM One)
Fitment:
- Fit for CRF300RX 2021-2025
- Fit for CRF300RL 2021-2025
- Fit for CRF300L 2021-2025
- Fit for CRF300 RALLY 2021-2025
- Package Includes: 1* Fender Eliminator and bolts
Cathy
Reviewed in the United States on February 19, 2025
Perfect fit
Colin
Reviewed in the United States on September 29, 2024
Fits my 2021 CRF300L perfectly, bolt on installation. Did not have to drill any holes out, the plug for the plate light fit through no problem.
Brandon
Reviewed in the United States on June 16, 2024
So many of the tail tidy kits for a 300l make you cut the wiring harness and I definitely did not want to do that on my brand new bike. This kit took me about 20 minutes to install and works great!
Willem
Reviewed in Australia on March 3, 2024
Went straight on works well, does as advertised
P
Reviewed in the United States on October 14, 2024
It is pretty light and seems descent quality. The only complaints I have is it doesn’t come with nuts and bolts for a license plate. You have to reused the plastic ones that come with your bike or go purchase some. Also, you need/should zip-tie the lights wire to the bottom of the assembly otherwise it droops down. Glad they make an assembly where I can use the OEM light and not cut/splice any wires on my bike.2024 CRF300L ABS
Customer
Reviewed in the United States on September 26, 2023
This kit comes with all the wiring, connectors, etc like all the other kits do. However, you actually don't need to make any cuts or electrical changes with this kit... Just unplug the existing light from the harness, unscrew it from OEM tail, and move it all over to the new kit. Took 15 minutes and again - no re-wiring needed. Easy.
Meagan Giuffrida
Reviewed in the United States on June 8, 2023
TL;DR - part fits the bike. The factory plug will not fit through the hole. You will have to cut the factory wires, leaving you a shortage point in the future.There a 2 holes for the factory plug to get back to the main connection. 1 hole was big enough. The second hole going back into the plastic isn't big enough. The only way to get that plug back into the bike, is to cut the wire from the factory light.Look back at the picture. You can see where the plug isn't going through the top hole. I have the gear to bore the hole... a $70 bit. Along with having to prime and paint.
JJS
Reviewed in the United States on October 1, 2023
Fits really good, and way better than spending 135 dollars on the "namebrand" one
Kasey b
Reviewed in Canada on April 18, 2023
Fits pretty good but the holes were slightly off had to bore out one hole a bit and it fit just fine. Seems sturdy and decent hardware
Recommended Products