Your cart is empty.
Your cart is empty. Garage Door Torsion Spring Steel Bearing ID 1" x OD 2"
(Used on torsion spring shafts and end bearing plates)
Feature:
- 1" ID 2" OD
- Used with center support only
- Rated @ 400 lbs for Center Plate
- 35'000 cycles up to 12' high doors
Size - 100% Size tolerance detection to ensure optimum Installation.
Seals - Double seals effectively prevent dust from entering.
Quality - Chrome steel manufacturing and end product detection.
100% SATISFACTION GUARANTEE:
Yoursme aims to provide the best service for our customer, if you're not 100% satisfied with our item, simply return it for a full refund in 30 days, no questions asked money back guarantee with 12 months’ warranty.
Our Yoursme product is 2nd to none, we aim to provide efficient and worry-free service for our customer,
If you have any problem about your order, please feel free to contact us.
Alw
Reviewed in the United States on January 6, 2025
Checked de fitting tolerance, was correctly. So install was without problems. I ordered it because they are perfect sealed so no dirt or dust can damage the bearing.
William & Eve
Reviewed in the United States on February 6, 2024
Looking at it I seriously doubt I'll ever have to replace them again. Sealed ball bearings made in China. Most times made in China means junk but these are a upgrade from stock bearings for sure. Used in a cargo box truck rear roll up door
Customer
Reviewed in the United States on November 5, 2024
This bearings have better quality than original on my door. I like it!
Steve
Reviewed in the United States on November 26, 2024
As other reviews state it is .095 inside diameter not 1" so it will not slide over a 1" shaft.
Michael J. Bane
Reviewed in the United States on October 7, 2024
These sealed bearings are very nice quality for what they are. people seem to complain that these are too tight, I did not have too much of an issue with them. They are snug but are by no means a press fit. If you have a corroded and or damaged rod/shaft you are probably going to have issues getting these on.
Netflex
Reviewed in the United States on December 29, 2023
Very tight on the pole but overall perfect fit for new pole without dents in it.
FREEMAN
Reviewed in the United States on June 4, 2022
Pros: bearing appears to be solid and well made. Rolls like butter.Cons: can't install it on garage door torsion bar. Inside diameter is too close to outside diameter of torsion bar. Requires extreme force (read: lots of hammering) to even get it an inch onto the torsion bar. I have to get two of these to the center of my torsion bar. They will more than likely be damaged by the time they make it there. Love the quality but come on. The ID doesn't need to be this precise for a garage door. Ordered different bearings since I can't use these.
Customer
Reviewed in Australia on October 13, 2022
good product
JLW
Reviewed in the United States on October 11, 2022
They work well and are quiet and smooth. I had to grind the bore a few thousandths to get them to fit my pulley shaft. They’re not exactly 1”bore they’re a few thousandths under. Still work great but took some fitting.
Recommended Products
$33.95
$ 16 .99 $16.99
$45.49
$ 22 .99 $22.99