Your cart is empty.
Your cart is empty.YUNGUI 12Pcs 50X100mm 2-3-5 Joint Hole Universal PCB Boards Single Side Copper Prototype Paper Circuit Stripboards Breadboard
Product Description
Quantity:12pcs
Size:5x10cm
Specifications: single-sided
Thickness: about 1.3mm
Pitch:2.54mm
Hole diameter:1.0mm
Material: FR4 Glass Fiber. copper
Package List
12pcs 5x10cm Circuit Stripboards
Brian Tamburelli
Reviewed in the United States on November 19, 2024
I live how these are patterned out like a breadboard! Great addition to my Electronics Laboratory Bench!
Slow Hand
Reviewed in the United States on July 25, 2023
I cut one of these up with a carbide-tipped chop saw. Expected it to break into flying pieces. It cut real clean. Then it soldered very well. Even soldered some SMT parts with paste and heat gun. All worked fine.
Glen Miranker
Reviewed in the United States on September 26, 2021
These stand up to the heat of soldering ok. Would be much better if they were plated (solder, gold) even just a "flash" plating ... to keep the surface from opxidizing before use.
Aleksander Malinowski
Reviewed in the United States on June 21, 2021
We used this board to create prototype circuitry to be connected to ESP32 development board. Many universal PCBs have either disconnected soldering potions or are arranged into connection strips that need to be cut. Some other boards mimic breadboard connections. The latter would be excellent except for the fact that ESP32 dev board is too wide to be used with breadboards and hence also with the PCBs that mimic them. This board is designed so that it can be used with the ESP32 when it is used off-center. So far this is the only such board I could find on Amazon.
Robert Scott Jr.
Reviewed in the United States on June 10, 2021
I like the varied trace configurations. I expect to cut out desired segments of a board to use in lieu of a terminal block to ensure good connections and greatly minimize space requirements. Nicely packaged and VERY quick delivery.
PBJ
Reviewed in the United States on December 29, 2021
Using a good quality soldering iron and two to three seconds soldering time, 1/5 traces will lift.Using an expensive desoldering gun every trace will lift.This stuff is garbage
R C
Reviewed in the United States on September 30, 2020
Most projects require integrated circuits and semiconductors, This board has proper hole spacings and I especially like the fact that it allows multiple (up to 4 solder) points for every IC lead connection. This is usually sufficient so one does need additional wire jumpers. Practical and affordable for experimenters and hobbyists.
Bryan Hord
Reviewed in the United States on December 24, 2020
These are exactly what I hoped they would be. The overall quality is fine for a phenolic PCB. The holes are drilled not punched, the traces are well formed but unplated. Unplated traces means it is super easy to cut and remove the foil with a hobby knife. The foil is very thin. Do not overheat and use only a temperature controlled soldering iron or you will have problems like the one reviewer had. Some lead free solders may dissolve thin copper foils.Phenolic is cheaper than fiberglass and splinters if cut improperly so use a saw. This would be frustrating for anyone starting out so spend the money on nice fiberglass protoboards with plated through holes if this is your first protoboard.These are really useful for quick sensor or audio projects that use 0.1" center components. They make builds extra fast and easy. They are inexpensive enough that you can build projects and not worry about using up all your expensive protoboard.
Recommended Products
