Your cart is empty.
Your cart is empty. 1. brand new and high quality.
2. Made of the high quality miniature optocoupler, anti-interference ability, stable performance
3. Adopt 9.5mm black barrier terminal and standard 30A terminal which is stable and reliable.
4. High/low level can be switched.
5. Available in three for you.
Specification:
Condition: Brand New
Model: YYG-2
Output Capability: AC 250V/30A, less than DC 30V/30A
Optional : DC5V, DC12V, DC24V
Weight: Approx. 49g / 1.7oz
Size: Approx. 67 × 40mm / 2.6 × 1.6in
Package List:
1 × One Way Relay Module
Customer
Reviewed in Mexico on August 14, 2024
Funciona bien pero el diseño es malo, no se puede atornillar porque no tiene espacio para que entren los tornillos
Customer
Reviewed in Canada on May 23, 2024
Product was as described. Used as an auxiliary relay to control the on/off of the main DC power supply for my permanent led control box.
S. Manning
Reviewed in the United States on October 24, 2024
I used it 3 times with a bread board and no issue, got everything mounted, wires cut to length, equipment mounted, and its broke already. I tested a bunch, took it all apart, thought maybe my ESP chip is borderline not enough power for the relay. Hooked up lab 5v power and tried a couple others, nothing. Everything else connected to the ESP chip still works like sensors etc. BIG waste of time!
PxZ
Reviewed in the United States on June 4, 2023
One out of 3 did not work, but they were very quick in replacing the bad unit.
Philip
Reviewed in the United States on June 18, 2023
relay lasted 3 weeks before it would not pull in anymore. Stickey relay. very poor quality.
ibmford
Reviewed in the United States on March 5, 2023
There's nothing much to report here. The relay works as expected, 30A side connector with screw terminal is sturdy and easier to hookup compared to smaller 10A relays.
Jill Elliott
Reviewed in Canada on December 27, 2023
Works as needed.
Corneliu Ciorici
Reviewed in the United States on November 6, 2023
Using this in combination with DigQuad to stop power to my trim lights when not in use for light show/display. Works very well. Simple and sturdy. Good strong connectors.
Scott
Reviewed in the United States on April 29, 2023
I got this to put a secondary over heat cutoff on my hot tub (it's a 120v one with the heat recovery motor, so no separate heater). It's been handling the load just fine and switches perfectly off an Arduino pin.
Mark Doe
Reviewed in the United States on February 18, 2022
Works as expected.
AndiBanana
Reviewed in the United States on October 5, 2021
What was sent is not what was pictured. First, it's too large with dimensions of 52mm X 77mm. The pictures indicated 40mm X 67mm. That alone means it won't fit for the needed application. Second, without any instructions or ability to read Chinese characters I have no idea what the switch, potentiometer, or "set" button are for. It might be a decent component but I have no idea and cannot use it.
Recommended Products
$16.99
$ 7 .99 $7.99