Your cart is empty.
Your cart is empty.This front trackbar will allow you to easily center your axle under your . One turn of the adjuster shifts the axle by approximately 1/16 inch at a time so you may fine tune your axle center very precisely. A perfectly centered axle is important to have for proper steering and "Quick Disconnect" operation. The body of the trackbar is made from 1.25" x .156 DOM tubing, bent to proper angles for various lifts. The body is then flat black powder coated for corrosion protection. Fits the following: - 1999-2004 WJ Grand Cherokee with 1" to 6" of lift Will not fit RHD vehicles.
Cory
Reviewed in the United States on February 21, 2022
This is almost the same as the JKS Track bar but the red bushings it comes with are trash. I assume the black ones that come with the JKS are better. For this track bar and then the Napa Bushings you are about $150, I would save the headache and just get the JKS if I had to do it again.
Statichead2k
Reviewed in the United States on June 10, 2021
The bar seems strong with good welds but the bushings are garbage. This bar was in my lifted grand cherokee for about a week before the bushing in the frame side gave up. The failed bushing caused nasty and unpredictable death wobble—for anyone that has experienced jeep death wobble, it is truly scary and dangerous even. I put my stock bar back in for now even though it makes my front axle off center, at least the car is safe to drive.
Travis
Reviewed in the United States on May 4, 2020
Looks okay. Not easy to adjust. Not sure I would buy again.
mark C adger
Reviewed in the United States on October 3, 2020
Great upgrade part.
Recommended Products
$127.00
$ 61 .99 $61.99
$19.99
$ 9 .99 $9.99