Your cart is empty.
Your cart is empty. 00-913149 NCC Temp Control Board Temperature Controller
How To Install This Part
1. Turn off the power to the Vulcan Hart oven and disconnect the power cord from the wall outlet.
2. Remove the oven’s control panel cover by removing the screws that hold it in place.
3. Disconnect any wires connected to the existing temperature controller and remove it from its mounting bracket.
4. Install the new temperature controller into its mounting bracket and connect all of the wires according to their labels or color codes. Make sure all connections are secure and tight.
5. Turn on the power to the oven and test that it is working properly by setting a desired temperature on the controller and observing that it is heating up correctly.
If not, check all of your connections again for any loose wires or incorrect wiring.
En lac
Reviewed in the United States on July 27, 2024
So far only issue two of the mounting holes are off, but managed to make it stay in place
RRubio
Reviewed in the United States on May 19, 2024
screws not included OEM screws will not work. new board is metric mounting thread
Bakery Savior
Reviewed in the United States on November 12, 2024
Since the original screws don't fit the new board they need to provide it
GL
Reviewed in the United States on October 10, 2024
Product has metric screw holes but there is nothing in the literature to indicate this issue. Had to return.
Dennis
Reviewed in the United States on October 18, 2023
original screws don't fit standard to metric and original knob doesn't fit . shaft on new part smaller than original knob falls off
Recommended Products
