Shopping Cart

Your cart is empty.

Your cart is empty.

10K OHM Linear Taper Rotary Potentiometer B10K Pot with Knob and 3-Pin JST-XH2.54 Connector Lead(Pack of 2)

Free shipping on orders over $29.99

$7.69

$ 3 .99 $3.99

In Stock


Linear Track Variable Resistor Potentiometer with tuning Knob and 20cm Flying lead with XH2.54-3P connector Track Resistance:10K Track Taper: Linear No. of Turns: 1 Shaft Diameter: 6mm Wire: 20CM Terminal model: XH2.54-3P Shaft Length - Metric: 15mm Resistance Tolerance: ± 20% Power Rating: 500mW Potentiometer Mounting: Bushing No. of Gangs: 1 Body Diameter: 15mm Operating Temperature Max: 70°C Operating Temperature Min: -20°C Shaft Type: Splined Voltage Rating: 500V


Carl
Reviewed in the United States on August 20, 2024
Works fine but there is NOT 2 in a pack as the description says.
MarkMannM2
Reviewed in the United States on November 21, 2023
Arrived OK however one of the connection tabs (positive lead) soon broke off. It will work ok for a very light application, however if you need something durable you may want to look elsewhere. MarkMannM2
Tom Kennedy
Reviewed in the United States on April 20, 2022
I guess I got what I paid for. Yes, this works, but the pot reaches full ohms after about a quarter turn. That should be in the description as generally one expects about 3/4 turn with one of these. I need a bit more control than that for my application so I will be getting something different and putting these in the miscellaneous electronics box for some future need that requires less precision.EDIT: It was not the pot - it was my VFD. I measured the ohms directly and it went from 0 to 10 ohms as it should. Sorry for jumping the gun on the review....
cat feeder
Reviewed in the United States on June 10, 2021
upgrade from the arduino stuff for sure
JonesMoto
Reviewed in the United States on June 21, 2020
I installed this as a speed control knob for a Wen wood lathe. The connection and mounting hardware were a perfect fit so I did not have to do any custom work to get it to work. Only had to replace one so since I got the two pack I have a back up.
ralph
Reviewed in the United States on December 12, 2020
Was using it to replace a pot on an old welder. Size was off by a bit and also the pot I ordered was the wrong resistance. Other than that it worked fine.
Bryank
Reviewed in the United States on January 19, 2020
Best price for 2 of them.
MBK61805
Reviewed in the United States on June 17, 2019
I looked around a lot and this seemed to be the best bang for my buck. I used it for a variable voltage lm317 circuit on an ATX to benchtop power supply conversion.