christopher sloane
Reviewed in the United States on March 6, 2025
good
Mark Soderquist
Reviewed in the United States on March 5, 2025
These clamps were used on 1 1/2" Vinyl pool water hose. They have great difficulty sealing the hose on barbed fittings. Most had to be replaced with standard worm screw clamps which sealed the hoses on the first attempt. Where the clamp is spot welded to the adjuster mech. seems to be the area that deforms the hose and creates leaks that can not be stopped even using double clamps.
Benjamin
Reviewed in the United States on March 1, 2025
well made and wide. holding intercooler piping on a rb25a r33
Jerry D
Reviewed in the United States on February 3, 2025
As advertised
Concrete907
Reviewed in the United States on November 2, 2024
These are not “THE BEST” clamps you can buy. Higher quality clamps exist. For starters, the bolt and nut are not stainless, though the rest of it is. But this is typical of all but the best (and pricey) T-bolt clamps. Just use anti-seize compound on the bolt and nut. Messy, but it prevents corrosion.When cost is considered, these deliver a lot for the money.
Simon
Reviewed in the United States on January 4, 2024
Work great!
G. Garrett
Reviewed in the United States on July 13, 2021
I had to take apart all the intake plumbing on the Jackson Racing supercharger kit on my Miata to get to a busted throttle cable, and took the opportunity to replace the original worm-screw clamps with these. These t-bolt clamps look better, hold the hoses more securely, and don't damage the silicone like the originals do. Still have to keep a few worm-screw clamps for the hoses that have tight clearance with the hood, or I'd have replaced them all.A note on sizing: If you can, measure the outside diameter of the hose you're clamping to better judge what size clamp you'll need (yeah, the hoses flex so getting an accurate diameter is tough). The inner diameter sizing is helpful, but these seem to be sized for silicone hoses with 4-5 layers, and with thinner walled hoses (2-3 layers) you may need to go down a size. 70-78mm work on my 2 1/2" hoses, but they're thin-walled and have a lot of the t-bolt clear of the nut when they're tightened. 63-71mm would probably be a better fit for me in that application, but there's a little overlap between sizes, so if you're only off by one size they'll still work just fine.
Todd Udell
Reviewed in the United States on December 4, 2019
using these for the carb boots on a ninja. the last owner lost them. the only problem is, they are a bit wider in person than the picture. looks closer to 3/4 inch but it's no big deal. they look nice and solid.