Your cart is empty.
Your cart is empty.
Features:
Installation without tools:
The wire mounting clip is suitable for 12 mm wide 5050 RGBCCT LED strips, and tool-free installation to meet your LED strip connection and expansion needs.
Use tips:
The pins of the connector and the copper sheet of the light bar must be tightly connected, otherwise please press the pins to make sure they are tightly connected.
Ensure that the LED light bar is located below the pin instead of above the pin.
Ensure that the light bar is cut along the cutting line.
When installing the waterproof strip, please peel off the silicon on the surface around the welding area.
Package include:
6 x L-shaped LED strip connectors
6 x Solderless LED light connectors
Warm note:
Manual measurement, please allow slight errors on size.
The colors may exist slight difference due to different screens.
John Crawford
Reviewed in the United States on January 21, 2025
They are very fragile and when attaching a long led strip can unclip and loosen very easily. Almost anything else would be better.
Dan M
Reviewed in Canada on January 14, 2025
Item does not make a full and proper connection causing the second strip of lights to not work
David V.
Reviewed in the United States on March 3, 2024
I tried very hard to follow instructions inserting each end of 2 led strips into the connectors. The only way to get the current to go through them is to weld the strips to the connectors. Not as advertised. Shame.
Jean Clarel Uppiah
Reviewed in Australia on May 6, 2023
All good!
Ron Dillon
Reviewed in the United States on March 28, 2023
These connectors worked very well on my RGBWW LED strips. easy to close, and had no connection issue at all.
Marie Harris
Reviewed in Canada on March 15, 2023
Broke the pins on my led strip. Used the double sided pin on the other side. Fixed it easy.
Ethan Tira-Thompson
Reviewed in the United States on January 2, 2023
Of the five connectors, I was only able to get one pin-to-pin connector working. The other four connectors had very poor soldering: one had pins shorted together, two had pins disconnected, one was barely holding together and completely pulled off the solder as soon as I handled it. The connectors for sliding onto cut strips were similarly problematic, they don't make good contact. Expect to do soldering if you want to make these actually work.
Kittrina
Reviewed in the United States on January 11, 2023
Bought for install on TV and cut to fit and use L shaped connectors. Spent way too long trying to fix it. Returned and had to order another led strip. Waste of time and money!
Angel
Reviewed in the United States on May 31, 2022
Have used this kit before to install light in other TV. Used this (my third set) and they were defective. Previous 2 set bought worked [perfectly. . The angle strips were loose on the socket. Giving a poor connection.. I do not know if I got a "bad batch" (no Star Wars pun intended) on this occasion, but connection was poor and looks like they used less plastic and the pressure area is smaller. Very disappointed this time with sell. Threw them away and just bended the strip on the corners, not happy and will buy with caution.
Rob
Reviewed in the United States on November 7, 2022
Long story short, it is amazingly difficult to maintain a secure connection across all 6 pins no matter what type of piece you use from the kit. You absolutely need an exacto knife/razor blade handy to make clean cuts on your light strip, make sure the cut is STRAIGHT at the point of connection, and remove any covering the strip had back about 1/2" from the cut to allow enough clearance for the strip to fit all the way under the connectors on the kit pieces. Good luck.
Zm
Reviewed in the United States on October 21, 2021
Should have listened to the other reviewers. Garbage, breaks easily, connections were not secure and not stable.
Recommended Products
