Your cart is empty.
Your cart is empty. Feature:
ITEM Size (mm): 5mm
Wire Length: 21CM
Forward Voltage (V): 12VDC
Forward Current (mA): 20mA
White Color MCD: 16000-20000 MCD
Lifespan: 50,000 Hours
Viewing Angle: 25 Degree
Pre-wired with built in Resistor
Color:6 Colors,Each of Color 20PCS(Red/White/Blue/Green/Yellow/Warm White
Package Includes:
120 X Pre wired LED Diodes Light
Ghassan
Reviewed in Saudi Arabia on September 10, 2022
ممتاز
Media V.
Reviewed in Canada on April 7, 2022
While testing, two suffered from poor solder joints causing leads to fall off. The working ones have a very poor coverage quality, many dark rings in the pattern. They are dim-ish to medium brightness, NOT bright at all. The current at 12V was only 9 mA, not the 20 or so that you would expect. At 25V the current did get up to 20 mA and the LEDs brightened up, but at that point the little series resistors got too hot to use. The connecting wires are too thin to make reliable connections (will break when flexed) and the colour code is wrong - black is universally used for ground/negative, not +12V. Basically a useless product.
Lewie
Reviewed in the United States on May 4, 2021
The media could not be loaded.
Customer
Reviewed in Canada on August 3, 2020
I bought 50 green 12vdc LEDs to replace 25 indicator lights of my boat DC control panel. When I randomly picked 3 of green led to try replacing 3 of my indicators found 2 LEDs lit and then off permanently - not working anymore!! Seems not good quality LED. So far I used 5 LEDs but 2 broken! I will wait for a while to see how stable and reliable those replaced 3 LEDs working before I decide to replace all of my remaining 22 indicators. I don't know what maximum DC voltage can go for the 12v LED cause when my batteries are in charge the voltage is 14.75v (not 12v).In addition the pre wired cables are too thin so that have to solder it in order to make it solid connection. I would like it a bit thicker 24 or 26 awg, for example.Installed 31 LEDs on my boat DC panel a few days ago. Today found 2 LED's stopped working. Now in total 5 LEDs broken (3 of them were totally dead before installed).Not recommend to buy this item!!Need to seek some other good quality LEDs🙄🙄
Rich L.
Reviewed in the United States on June 30, 2020
Happy with the quality, packaging and punctuality. The reason for the reduced rating? I only got 100 lights and the color missing is the one I was looking forward to using the most. Unfortunate but not the end of the world. This purchase would have been a great value if I had received the other 20 lights.
Prof. Wu
Reviewed in Canada on January 13, 2020
Because these have a resistor I have used these on 3.7v to 16v without any issue. As for super bright, I'd say one lit would be the bare minimum to find your keys in the dark, When you look directly at the led it is bright but, the actual light cast is somewhat low. If you want brighter go for 10mm
Deal Hunter
Reviewed in the United States on June 14, 2019
I have several expensive (near $100 each) lighted post caps from a brand that rhymes with T-Rex and they have steadily failed over last several years. The lighting circuit was way over engineered with a circuit board to house the resistors. There was no humidity protection which led to corroding and ruining the resistors making the light useless. I was able to disassemble the post cap, remove the circuit board and lights and gang eight of these together to connect straight to the power. Now the connections are soldered and shrink wrapped so no worry about corrosion in the future. Resistors are wired straight in so everything is ready to go. You'll need a very small wire gauge stripper and the leads are very delicate so handle gently. Ordering 50 more to complete the rest of the caps as they continue to fail.
anonymous smith
Reviewed in the United States on December 2, 2019
Well, they all light up. Quality control seems good. All had good wiring.These lights have clear plastic globes, with different color led units. All are adequately bright. The orange is not so orange, but rather a orangish whiteish light. Fit my purposes though.Very good price, fast shipping, good packaging. I'd recommend or buy again.If this review helps then click so.
L. Stevens
Reviewed in the United States on November 18, 2019
The first thing to know is they are highly directional giving a very narrow beam. They are as directional as the image would suggest, they do not illuminate like an old light bulb -at all. that does not mean they have to be avoided however. I used them as dash indicators but only after adding a 200k resistor. I highly suggest 50-250k for dimming them for a switch panel on/off light. They can be series wired and used as cargo box lights but they are a better for indicator, spot light,strip light kind of use than say an under hood illumination light because they are so directional. They make a good very narrow beam flashlight and they worked great for my 12/9/5/3 v DC power supply project as on off indicator for the 3volt lead because they did work well off only 3volts.
EkV
Reviewed in the United States on October 17, 2019
Fantastic little LEDs. Standard size and brightness. Great for the price and excellent for hobbies/ what I need them for. Includes an inline resistor that's soldered and heatshrinked over. Works with 3-14v (just from what I've tested). My only complaint is that on most, NOT ALL, but most of these, the colored wire is connected to negative post on the LED instead of the positive post like its supposed to be. The black goes to the postive on the LED on most of these. So it can be confusing when you go to wire them up and it doesn't light, swap the polarity and you'll be fine. Not a big deal for me but a minor annoyance.
CC Rider
Reviewed in the United States on September 11, 2018
I needed some 12 volt DC LED's in various colors for ongoing vehicle projects and these fit the bill perfectly. They're pre-wired with leads, which make hookup and soldering easy. All of the LED's worked fine and they are bright enough to use as an indicator yet not too bright for use on a vehicle at night. The polarity is kinda backwards from how you would suspect. The black lead is positive, not ground and the colored lead is negative. Not a big deal.Quite a bargain for a bag of great little LED's...
Zzyzx Oh
Reviewed in the United States on December 12, 2018
I needed a little test light for a 12-volt automotive project. It involves an adapter from the fuse box to a wiring harness so I can see what fuses are hot with the low beams, the high beams, and the fog lights. I used a piggy-back pigtail to tap into the fuse box and wanted something cheap and lightweight to get my attention when the power was on or off.I bought the 120 bulb assortment because the price was right. I took five (5) different LEDs and wired them in parallel and touched them with a bit of solder. I then fed the leads through an empty candy bottle and added a fast disconnect crimp connector on the tinned leads.The result is a lightweight and cost-effective test light that won't leave a mark if you bump the paint or plastic on a car and the light of five LEDs seems bright enough to get my attention in all but the brightest of areas. Need more light, add more LEDs.The fact these have leads already attached was a big time saver for me. So far all units tested work. I have also ordered some panel bezels to put a few of these bulbs into the face of a project box. They are nice.The photo was taken in a room without lighting using the Night Sight mode of my cellphone. The actual impact of the light is brighter to the human eye but the cellphone auto-adjusted when the room lighting was on and you couldn't see the jar was lit in the photo, but you could see it live and in-person. This imager fairly depicts how the LEDs appear.
Andrew S.
Reviewed in Canada on April 14, 2018
These are great, very bright .. they're not weather proof but you can modify them to be weather proof by adding some watertight shrink tube to the base of the LEd to seal the wires. Also, there are no instructions with these(not that you need them) however for those that test them or connect them and don't understand 12v .. the colored wire is not the positive wire, it's the Negative wire . The black wire is the 12v + wire .. if you connect 12v + to the colored wire, the led will not illuminate, nothing bad will happen, just switch your power and ground .
Recommended Products
