Your cart is empty.
Your cart is empty. Specification:
Color: black
Material: stainless steel
Product Size: as shown in the detailed picture
Package details:
12 x rear license plate screws
Note:
Due to manual measurement, the size and weight may have a certain error.
Due to the difference between monitors, there may be a slight color difference.
joshua
Reviewed in the United States on March 4, 2025
The screws worked fine for my project, but the quality wasn’t as good as I expected. A few stripped easily, and some didn’t fit as well as they should have. They’ll get the job done, but I’d look for better ones next time.
Justin
Reviewed in Canada on August 18, 2024
These fit the OEM BMW license plate cover (used for the past 20+ years on every model).However, if you run any sort of license plate cover/frame, it will likely NOT fit, due to the short length of the screws. I recommend buying a slightly longer screw (like 12mm) if you want to use a license plate frame.
Pataka Lang
Reviewed in the United States on August 10, 2024
I only needed 2, but cheaper than buying 2pcs at big box store.
Denys Bielov
Reviewed in the United States on June 29, 2024
It is just a machine screw and it does it’s job
Customer
Reviewed in the United States on June 23, 2024
Worked perfectly for my 2020 Model Y. The 10mm was long enough to attach my license plate, the clear hard cover, and the metal frame. I will update if these screws start to rust.
Sonia
Reviewed in the United Kingdom on May 31, 2024
Previous ones had rusted needed a replacement. Ordered these value for money, good quality and easy to install.
Joshua Vela
Reviewed in the United States on March 5, 2024
Not much to say here, They're black screws that fit my BMW license plate holders. They worked great! and there black! So recommended if they fit your use case!!!
Damien Brook-Jowett
Reviewed in the United Kingdom on March 31, 2024
Not suitable for rear reg plates. Too thin and too short
Jeff
Reviewed in the United States on March 11, 2024
A few bucks cheaper than some others out there. Used it to attach license plate to factory installed plate holder. Fit my 2021 Tesla Model Y rear plate no problem. I got the 8mm length which were long enough but didn’t seem to bottom out against the bumper.
Big Dawgs Fam
Reviewed in the United States on February 4, 2024
Got this for our Tesla Model Y rear license plate frame, the one that came with the car is ridiculously short if I use any license plate frame, it can’t reach. This works very well, it is a bit long so if you are worried that the screw might hit the trunk, just put a tape on the back, I wasn’t too worried as the frame I am using is a thick silicone frame. Nice quality screws!
michel beaulieu
Reviewed in Canada on December 19, 2024
Bon vendeur et rentré dans les temps.
Najm Addin
Reviewed in Canada on November 7, 2024
Perfect size
Mike B
Reviewed in the United States on October 12, 2024
Made of cheap plastic. Misleading description don’t buy
Recommended Products
