Your cart is empty.
Your cart is empty.Sbalak
Reviewed in the United States on March 18, 2025
I used this in a tractor. Fits standard slots pretty well.
Chris Grindstaff
Reviewed in the United States on September 26, 2024
Nice replacement switch. Really like the way it lights up different for each mode. Simple to wire up following the easy instructions.
Julien b.
Reviewed in Canada on September 22, 2024
Nice
One Man Show
Reviewed in the United States on August 26, 2024
Good quality, very ez to install, even in the custom application I have. Was very surprised how ez the wiring was. This is a good value.
Russel
Reviewed in the United States on March 10, 2024
Had to pull one of the wires and the entire metal tab came out with it.
Gilberte
Reviewed in Canada on December 18, 2024
Utiliser dans Polaris.
Derek claytor
Reviewed in the United States on September 1, 2023
Worked as expected and had instructions in case you don’t know how to hook it up.
Rob Forrest
Reviewed in Canada on June 30, 2023
The product works are described. Fit factory wiring harness. We will she about longevity.
Geat product
Reviewed in Canada on June 23, 2023
Put this switch for my SXS and works great.
James Syrette
Reviewed in Canada on November 26, 2023
Works well . Overpriced though
Lukevos
Reviewed in the United States on April 9, 2023
Exactly what I needed for my KC Flex Era 4 lights! My lights have two settings. One setting is a low amber light and the other is a high beam. The switch was perfect because it had two toggles for both modes. I switch it down for the low lights and up for the high lights.All I have to say is measure twice and cut once. It doesn't come with a template to cut the hole for it. I lucked out and made it work. Fit perfectly on my dash after cutting a hole.I would buy this product again!
Peter buck pottruff
Reviewed in the United States on July 4, 2022
I had a little trouble with the wiring so make sure you have a good GROUND. But very nice switch the lights are a nice bright eye catching red. And it does blink which the ad was unclear about.
John L.
Reviewed in the United States on June 23, 2022
Works exactly as it should. I wanted a Nav/Anchor switch with red backlighting. It fit in my Contura breaker panel without issue. I wired it using the googleable 7-pin wiring diagram for NAV/Anchor lights, and it works perfect. I like that the backlighting for both NAV and ANC turn on when in the UP position, and only the ANC backlight turns on when DOWN. The included jumper wires have spade connectors which connect to the switch terminals very strong. My only issue was that the spade terminal for the ground pin for backlighting became a bit loose in the switch body after disconnecting / reconnecting it a few times. If I had connected it just the once, I'm sure it would be rock solid. My recommendation is to be sure of your spade connections before pushing them on, and if you have to disconnect things use a flat screwdriver to pry them off as opposed to just pulling the wires.
Recommended Products
