Your cart is empty.
Your cart is empty.Scott P.
Reviewed in the United States on February 19, 2025
Nice job this is the perfect replacement for something I had Broken off due to rust.
AME
Reviewed in the United States on July 25, 2024
Plastic t very small. Worked well but would have liked more.immediate torque.
Chris Davis
Reviewed in the United States on July 22, 2024
I bought these to hold my canopy up for my boat. It’s absolutely wonderful to be able to twist these babies in instead of using a wrench.
Rick
Reviewed in the United States on August 24, 2023
I needed a more substantial handle to exert the torque to lock an awning support rod. The finger knob is too small unless you only need a small clamp force. They may be fine for something like a camera tripod.
Jared
Reviewed in the United States on August 22, 2023
Fits most boat biminis
StephenH
Reviewed in the United States on August 15, 2023
My RV awning came with screws with disk shaped knobs. I was having a hard time getting a good enough grip on them to tighten them sufficiently to hold the awning in position These are much better as I can get a sufficient grip to lock the arms in the position I want them. I did make a mistake of ordering them a little too long. I should have ordered 3/4 inch. However, a little work with a Dremel tool adjusted the length. They appear to be holding up well.
Ninh
Reviewed in the United States on October 4, 2023
Quality build. I wonder why it is USA made.
KK
Reviewed in the United States on December 30, 2022
They work just fine on our boat, but with some things to know. These can be just a tad bit too long on a couple spots, but rubber washers can be used to take up the slack. A rubber washer also helps prevent the screw from backing out from vibration as well, kind of like a lock washer. With the Wing Knob, they are significantly easier to tighten by hand than the ones that came with the boat.
Recommended Products
