Your cart is empty.
Your cart is empty.Product Description
Why should we replace the old AC compressor clutch?
The AC compressor serves the purpose of converting the low-pressure refrigerant into a high-pressure refrigerant and sends it to the condenser. It is the central component that maintains the pressure difference between the high-and low-pressure sides of the AC mechanism. Proper lubrication is essential to prevent the compressor from premature wear. A bad compressor, of course, will not send the refrigerant under the required pressure, thereby failing to provide optimal cooling to the vehicle.
How to install?
1. Always wear eye protection.
2. Remove the failed compressor. Transfer any switches, sensors, brackets, or manifolds from the original compressor to the replacement unit.
3. Thoroughly flush each component not being replaced with an approved AC flush solvent.
4. Replace the accumulator or dryer and all expansion devices. including the orifice tube and screen.
5. After installing the replacement compressor on the vehicle ensure proper mounting and belt alignment.
6. It is recommended to install an in-line filter in the suction line near the compressor inlet.
7. Add the proper type and amount of ac oil as per manufacturers procedures.
8. Apply a vacuum to the car ac system. A minimum of 29 inches of mercury for one hour to insure moisture and residual flushing solids or boiled from the system.
9. Recharge your air conditioning system using the recommended Freon.
10. After you finish your repairs, conduct a complete system performance test.
Claude
Reviewed in Canada on July 27, 2024
One star cause I couldn’t choose zeroBearing lasted not even one dayCheap garbage
Karah
Reviewed in the United States on February 25, 2023
I installed this on my 2006 Chevy Express 3500 and it fit as said it would but within 100 miles the bearings went out and clutch ceased to work and AC would no longer work as a result! Absolutely junk bearing! Hopefully for everyone else, I got a Lemon but be cautious if buying!
Michael L Heim
Reviewed in the United States on January 22, 2020
I got my old AC clutch off and put this one back on only to find that the connector was the wrong size. It said that it would fit my truck, which it did, but the connector was incorrect. Luckily, I had a soldering iron and some heat shrink, otherwise, I would have been screwed. If you get this for a Chevy Silverado, just be prepared to solder the old connector on the new clutch.
B. Votaw
Reviewed in the United States on September 5, 2019
Did not fit my chevy 99 Silverado as advertised.
Recommended Products
$39.97
$ 16 .99 $16.99